At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.
i am so sorry i don't know why it our chat ended please forgive me contact me again if you want and thank you.i am so sorry i don't know why it our chat ended please forgive me contact me again if you want and thank you.
Re: key stuck in the ignition and wont let me out of gear
The shank of any GM key hits a lever that locks the key in place when turned into any position other than the off position. If it stuch in off, the cylinder must be replaced
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
It has to have power to remove the key. Jump it with another battery or charger. If you have power from the battery and no power to the inside. Check main fuses under the hood. If those are good, put power to the cigarette light, This will get the key out. Most likely have to replace the under hood fuse panel.
Hi Suzanne make sure youy gear lever is in park. Operate it a few times it may have a dodgy switch which will prevent key from being removed. Regards Jim...
THe key has a code in it that is read by the engine immobiliser. BY removing the key and reinserting you are giving the immobiliser a chance to read the code again. Give it a try. THe battery in your key may be getting low and needs replacing.
This can happen if the battery is low / dead. To solve, connect a set of jumper cables between the battery in the Cobalt and a running car's battery. Shut off the running car. In the Cobalt, make sure all accessories (lights, radio, fan, etc.) are off. Step on the brake, then move the gear shifter fully into the PARK position. Next, either attempt to start the engine, or turn the key to the OFF position and remove it from the ignition.
Your shifter cable sounds like it separated from the transmission or shifter or just broke. you are probably stuck in a moving gear so the neutral safety switch is disabling the ignition.
Some chrysler vehicle have a button in front of the ignition on the steering column that has to be pushed to remove the key other wise replced the ignition cylinder itself
Ignition - Key Stuck In Ignition Switch/Won't Turn
Bulletin No.: 06-02-35-005
Date: February 28, 2006
TECHNICAL
Subject:
Key Stuck in Ignition, Key Will Not Return to Off Position, Shifter Button Won't Release in Park Position (Adjust Shifter Detent Finger)
Models:
2002-2005 Chevrolet Monte Carlo
Condition
Customers may comment on any of the following conditions:
- The key is stuck in the ignition cylinder.
- They cannot return the key to the off position to remove the key.
- The shifter button won't release in the park position.
Cause
This condition may be caused by the detent finger shifting over time. This may result in mis-alignment and binding of the shift rod on the shift position guide.
WHERE YOUR SHIFTER IS YOU WILL HAVE TO TAKE IT APART ..MAYBE THE RUBBER BOOT IS IT THE WAY,OR THE SHIFT LOCK SELINOID WHENT BAD
Where are you???
ok im here
can sumone help me
i am so sorry i don't know why it our chat ended please forgive me contact me again if you want and thank you.
still there
×