If i pour gas into the air intake , it runs fine till i stop pouring gas in, it won't start on its own, new fuel pump and fuel filter, fuel pressure is good, new computer, new crankshaft sensor, all the fuses and relays are good,all the wiring looks good i doubt if all the fuel injectors went bad all at once. so what else could it be?
Its the vats system it shuts off injector pulse when it doesnt detect the correct reading from the chip on your key
The problem is the fuel injectors are not pulsing to deliver fuel, check to see if u have 12 volts to one side of the injector connectors, if not check the underhood fuses and the passenger fuse box, if that is it and it runs and blows the fuse again then u have a shorted engine wiring harness.. also buy a tool called a "Noid" (about $5) fuel injector tester, it plugs into the injector connector and blinks when the eng is cranked, if it doesn't blink this confirms that u have no injector pulse and no fuel delivery.
THIS WOULD BE A WIRING ISSUE OR A COMPUTER PROBLEM, DID U INSTALL THE PROM (PROGRAMABLE READ ONLY MEMORY CHIP) IN THE NEW/REBUILT COMPUTER? THEY DON'T COME WITH THE PROM IN MOST CASES, CALL THE STORE WHERE U BOUGHT IT. FOR MORE INFO ON YOUR PARTICULAR CARS COMPUTER...
×
Possibly a blockage on carb fuel inlet
600 views
Usually answered in minutes!
injectors are getting 12 volts to one side, gas is getting up to all the injectors , just not going through them...if its not getting an injector pulse?, what could be the cause?
they probably didnt whent bad but they could be dirty too..?
×