92 4 runner HATCH ISSUE!

the release at the bottom of hatch can be ---rusted normal in northeast --- linkage popped or broken --linkage clip popped or broken --- need to crawl into back and remove the plug [ lower center of rear hatch panel will need a long screw driver and light will see linkage and latch push down on linkage arm and push open hatch when opened you can remove the rear panel and assess the problem but lube the latch and upper window latch

Hello,

To replace the left rear turn signal light, please follow the steps below:

1. Open the rear hatch of your van.
   
2. There are two black button like protrusions behind the hatch next to the turn signal lamp.
   
3. Pry these out and remove lens.
   
4. Replace bulb.
5. Then reverse the process th reassemble the hatch back together.

Hope this helped. Thank You for using FixYa!!!

open the rear hatch and on the left inside behind the tail light should be an cover. That will open to see the back of the light and then remove the bulb and replace with new

The headlight, brake and turn signal all run out of the turn signal switch. this is what causing you to loose those items. the door is a clip that has broken inside the door that goes to the handle, you will have to take the door panel off to find the rod that is hanging

Normal 0 false false false MicrosoftInternetExplorer4 /* Style Definitions */ table.MsoNormalTable {mso-style-name:"Table Normal"; mso-tstyle-rowband-size:0; mso-tstyle-colband-size:0; mso-style-noshow:yes; mso-style-parent:""; mso-padding-alt:0in 5.4pt 0in 5.4pt; mso-para-margin:0in; mso-para-margin-bottom:.0001pt; mso-pagination:widow-orphan; font-size:10.0pt; font-family:"Times New Roman"; mso-fareast-font-family:"Times New Roman"; mso-ansi-language:#0400; mso-fareast-language:#0400; mso-bidi-language:#0400;} Lift the hatch. The tall center light is located behind the upper hatch inside panel. There are two panels need to remove. One panel is on the right, the other on the left. To remove the panels you have to use flat screw driver to pry out the panel in several locations. (These panels are secured by several small metal clips.) Be careful to collect all these clips and replace them on the back of the panel. You will need these clips to replace the panel later on. After remove the panels, you will be able to locate the screws on the tall center stop light assembly. Remove those screws and cover. After replacing light bulb. Assemble everything in reverse order. Remember, the metal clips have to set on the back of the two panels not the car body.

Open hatch and on inside of body where the lens is are two horizontal screws going into the lens, remove them and pull the lens towards the back of the vehicle carefully. Good luck

Open the full hatch.
Pull down the weather strip near the rear dome light.
There should be a wire with a connector in it. Disconnect it
Close the full hatch.

Open just the window hatch. There is 1 screw on either side of the bulb housing.

left tail light is not real. Have a look under boomper. Ther is no kable. Is only one tile light in most of cars.

First you need to lift the hatch. There are two screws under plastic caps. Remove the caps and you will be able to unscrew these screws. Carefully using a flat screw driver to pry out the tail light assembly. It have to plastic pin that attached to the car body. do not break the pin. After you pry out the tail light assembly, you will be able to replace the light bulb. Replace everything in a reverse order.

open hatch, look for two screws, remove , push tail light gently back and forth to release from clips pull light assembly out , twist bulb socket to remove from housing, replace bulb.