SOURCE: Cylinder number for firing order for 1995 Isuzu Trooper
Hi,
Assuming your 1995 Isuzu Trooper is using the 3.2 SOHC engine, the firing sequence would be as shown here.
. This was originally posted here. An actual image which was originally posted here.
Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.
Good luck and kind regards.
Thank you for using FixYa.
SOURCE: firing order for gmc jimmy 1999
-Drivers side starting at the front of engine: 1-3-5
-Passenger side starting at fornt of engine: 2-4-6
SOURCE: what's the firing order is for a 2002 mazda mpv 3.0L/6 cylinder engine?
Thanks for using FixYa - a FixYa rating is appreciated for answering your FREE question.
SOURCE: firing order for 1966 ford mustang 200 cubic inch
The engine is a 200 CID straight six, the firing order is 153624...
Just pop the distributor cap and have someone crank the engine while you
watch the rotor.
How I can determine which hole in the distributor is assigned to the #1
plug wire.
Pull the number one plug. Turn the engine over slowly (with a wrench)
while holding your finger over the plug hole. When the air builds (a lot
of) pressure you are coming up to the number one spot on the
distributor. (the rotor will point to the location of the #1 hole in the
distributor.)
Quick methods to disable the engine I have seen people do on the
classics:
Close the points by loosening the set screw
Pull the rotor cap
Connect a wire from the coil to ground. (effectively closes the points.
Can damage the coil if key is left on.)
Pull the main ignition wire
And there are some tricks at the starter solonoid involving the ballast
resistor bypass that is used to provide a hotter spark while cranking.
(Two little wires at the starter solonoid - one is crank the other is
the ballast bypass.)
Might give those a look-see. Best of luck (rememeber rated this help).
Testimonial: "This has been very helpful!! Thank you!"
2,879 views
Usually answered in minutes!
×