Where is it located in the trunk? I have read 3 different postings -- one says it is on driver side in trunk, one says it is on passenger side in trunk, and one says it is in the middle of the deck lid in the trunk where the wiring is for my spoiler light. Any answers out there? I have a replacement fob to program.
Removal Procedure
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
Disconnect the negative battery cable.
Open the rear compartment lid.
Remove the remote door lock receiver (2). The receiver (2) is located between the rear package shelf and the rear package shelf cover, to the right of the center access hole. Compress the 4 tabs and slide the receiver (1) down through the access hole.
Disconnect the electrical connector (1).
SOURCE: programing keyless entry
If you have an owners manual the programming instructions are in there. If no manual here they are:
1. Turn the ignition off.
2. Ground the receiver program terminal. Jump the two terminals located in the programing ground connector. (What this means in simple terms is locate the wires that run on the right side of the trunk. There is two black wires that has a plug on the end with two prongs. It is in between the antenna and tail lights.)
3. Within 2 seconds of connecting the prongs the door locks will lock. The unlock and the rear compartment lid release will produce a cycle, causing the horn to chirp. This indicates that the module is ready for reprogramming.
4. Press and hold the lock and unlock buttons at the same time until the doors lock and unlock. The rear compartment lid will release and the horn sounds to indicate that the transmitter has successfully been reprogrammed. (Hold buttons down for approximately 12 seconds)
5. Repeat the previous step for the remaining transmitters.
6. Remove the jumper at the program connector.
7. Verify the proper operation of each transmitter
SOURCE: program a keyless enrty remote start 2004 chevy malibu
Dealer only If you find a different means let me know
SOURCE: 2008 chevy malibu. how to program keyless entry remote
You must take it to the Chevy dealer.
Testimonial: "thank you"
109 views
Usually answered in minutes!
×