Need to change the clock in i30 hyundai
Your owners manual should have a section explaining how to change he this in cases like the battery dying. Look in the table if contents in the back for clock and it should tell you what page the solution is on
SOURCE: How do I get the clock change time?
FROM THE OWNERS MANUAL:
Setting the clock: Press RDS until SELECT HOUR or SELECT MINS
is displayed. Press SEL to increase ( ) or decrease ( ). Press
RDS again to disengage the clock mode.
SOURCE: changing time on clock in 1997 olds bravada
To set the time turn your radio off. Then hit the set button, then seek button changes minutes and scan changes hours.
SOURCE: 2003 Hyundai Santa Fe clock stopped working
1. Be sure there is no play in the fuse holders, and that the fuses are held securely. 2. Are the fuse capacities for each circuit correct?
SOURCE: How to set the clock for a Hyundai Getz?
hi from uk ! to set clock/time on getz look t the speedometer ? you will see two buttons on the bottom of dial ? the left button is to cancel the trip meter by pressing button in for trip A and again for B trips the right hand button marked hr + min ? to set hour time turn to left untill hr time is shown then release now turn button to right to set the minutes then releas when time/minutes ar correct that is it! ps you cannot cancel the odometer/milage clock only trip meter hope this helps best wishes from n/west uk
Testimonial: "Thank you very much, your instructions were perfect :)"
Try this, put the key in the ignition and let it be on the first
turn right marked "ACC" or you can turn off the stereo and you will notice that
only the Digital Clock screen will show. Turn the Volume/Audio/Sel knob and press
on the "DISP" button simultaneously for about 4 seconds then release the "DISP"
button. The digital clock will start blinking, and then use the Tune/Seek
arrows pointing up and down to change the time. If the hour digit is blinking change
the hour and after you have changed it press "DISP" then the minute digit will
start to blink change it using the arrows, when you are done press "DISP" again
or leave the clock for between 4 to 8 seconds the clock will start working
normally.
I hope this works for you.
Good luck!
Aquinas
843 views
Usually answered in minutes!
×