20 Most Recent 2009 Hyundai i30 1.6 Questions & Answers

It can be tough driving without a warranty, but I recommend that you get it from some place else. If you need help, I recommend the link below. http://drivesmartwarranty.com/

What is wrong with trading it in and get something you are use to.

What is wrong with taking it in the shop?

I have no idea.

have autozone run obd test and retrieve obd codes

there are many parts included in emissions most of it is located just above gas tank

Look at the throttle cable where it connects to the air horn and moves the shaft that controls the butterfly to let air in the manifold . Even if it says its not adjustable usually is a small stop screw that you will have some control over how far the air inlet butterfly will come to a stop position .This will control the amount of intake air less air slower idle . However you may have other issues .

Instrument panel may b failn. Or a sensor...a fuse etc. Disconnect batt and see if it clears. Call napa for details

Hello

The Engine and Automatic Transmission (not applicable to manual transmissions) in this vehicles drive train are fully electronically controlled by a computer called the PCM and TCM (Power Train Control Module, Transmission Control Module). When a problem like this or other drive-ability related problems occurs the computer stores a record of the problem (there are of course some exceptions to this, like the fuel pump, engine coolant temperature sensor and MAF sensor for instance) in the form of a fault code in its memory, to read these fault codes you must have the systems memory scanned with a special tool. Once the fault code(s) are read you then must perform the appropriate diagnostic testing to find and resolve the problem(s) DO NOT REPLACE ANY PARTS UNTIL A TRAINED TECHNICAIN HAS DIAGNOSED THE PROBLEM TO AVOID SPENDING YOUR HARD EARNED MONEY ON PARTS THAT MAY NOT CORRECT THE PROBLEM. Also always check fuel pressure for correct spec for your make and engine type.

if you can find the jack there should be a picture on it, one spot is usually behind the front wheels just inside the sill(pinch weld), its like a double layer of steel(reinforced).

which door, please be specific on the problem. It wont unlock or froze shut, what were you doing when you tried to open it. Are the handles free? If you need further help, I’m available over the phone at https://www.6ya.com/expert/david_4c166ba81493f541

mines was went an was an electrical fault in engine

use your phone to record the sound then take that to a good mechanic they cant deny a recording. it is possible the sound could be coming from the starter motor.

It's supposed to be a safety feature..... If the car isn't in park then the key is locked in the ignition

you can find many codes on yahoo. just enter the search information with the model number of your devise .although it has also been my experience that the default code is 0000 "4" zero's

Try turning dimmer switch higher most do work better at night because its darker try to keep head lights off in day time should he If you need further help, I’m available over the phone at https://www.6ya.com/expert/richard_b59056c0c62ecb00