Bmw X5 reset code P0442 once fixed?

SOURCE: 2003 BMW X5 radio display lights

BMW has a free fix for that! It's a factory recall with the pixels. Check with your dealer.

SOURCE: Location of Oilf Filter on BMW X5 4.4i V8 Engine

Hi, the oil filter is located on the underside of the engine next to the oil drain plug usualy black in colour, hope this helps. regards mark.

SOURCE: Location of Oilf Filter on BMW X5 4.4i V8 Engine

Depends on the engine, if its a M62, its under the hood, torwards the front drivers side. If it a N62, it is on the underside of the vehicle, next to the oil drain plug. Its the black plastic housing with a 6mm allen bolt in it(thats used to drain the oil out before removal)

SOURCE: How do you turn off BMW X5 tire pressure light

On some X5's you can do it through the instrument cluster whereas other through the button on the centre console depending on the spec.

On the centre console you'll find the tpc button. It looks like a flat tyre with an exclamation. With the ignition turned off, press and hold this button and turn on the ignition to position 2. You'll notice on the instrument cluster the light go red, yellow, off and then come back on yellow. When the light comes back on yellow release the button and wait with the ignition on until the yellow tpc button goes out. Thats it.

If this hasnt worked you have a different spec and therefore a different way of doing it! Let me know and il guide you through it.

Hope this helps!

Radio Code Pro

• 2200 Answers
• Posted on Jul 29, 2009

SOURCE: I have a 2003 BMW X5, how do I reset the service indicator?

Hi,

You can reset your service indicator, as follows:

1. Get in the car, close the door, buckle the seatbelt.
   
2. Push in the clutch pedal and hold it to the floor
   
3. Press the left hand dash button (the one that resets your odometer) and hold it down
   
4. Put the ignition key in the key slot, and turn it gently (very gently) until the dashboard lights come on - the key will not click - if it clicks you've gone too far and you have to start again. Hold the key in this position. In five seconds or so, the dash will display "SIA" and some other characters. Do not proceed until this happens.
   
5. Release the dash button (and only the dashboard button) and then press and hold it again. In another 5 seconds or so the display should begin to flash "RESET?" Do not proceed until this happens.
   
6. Release the dash button and push it again to confirm. You won't need to hold it - the display should change immediately and your service indicator will display five green LED's.