How can I remove the old window tinting on my 2005 Accord rear window with defrost strips without leaving the glue behind? I'm in the middle of steaming the tinting off, which is working some-what O.K., but it is leaving the old glue behind. Easiest way to remove the glue?
SOURCE: 2005 Honda Accord
behind the inside door handle by removing the inner cover you well find two screws remove them by the inside grab handle on the door there is a small rubber mat remove the mat on the upper right corner is a trim piece it just pops off once the screws and trim is removed use a small screw driver and go below the door panel and wedge it between the panel & door and pull back on the screw driver until you here a pop the door panel is held on by plastic clips :caution--when removing the panel DO NOT YANK ON THE DOOR PANEL. THE INSIDE DOOR HANDLE IS STILL ATTACHE D TO THE DOOR PANEL. if you dont unhook this cable before removing door panel you will break the plastic end of the cable if you break this you will have to replace the cable then this well involve removing the latch because the cable is hooked inside the latch hope this helps
SOURCE: Honda Accord brake light removal
It's a lot of work for just cleaning.
Fold the rear seat down and remove the two 12mm bolts on the bottom corners of the seat back, pull the seat out.
Between the seat bottom and the carpet you will find two tabs you need to pull and then pull the seat bottom up and out of the car.
Remove the two 10mm bolts securing the seat bolsters to the area the seat bottom was covering. Pull the seat bolsters up and out of the car.
Pop the "C" pillar trim off of the car (above the parcel shelf and beside the rear glass) (side airbag vehicles have a slightly different procedure.)
Pull up on the parcel shelf carefully and evenly. Remove clean and put everything back together.
SOURCE: 2005 Honda Accord Front Bumper cover replacement
easy there is a screw on both sides were bumper and fender meet just pop back fender liner its a phillips head. Then pop hood remove clips on black trim infont of radiator. Underside where bumper goes under car remove those clips and 10mm bolts after all is removed bumper just pulls off ...... may have to give it a hard **** a few times but it will come off. Should only take 15-20min to remove if its your first time
SOURCE: 2008 honda accord replace rear brakes
no, 12mm wrench or ratchet on 12mm socket. the piston is tough to push back in. its a twist in type and you will need some force to push and twist the piston back in. - note rear brake pads wearing out on the new 08-09 accords are very common and if under 16-18 thousand miles it may be covered. honda knows about this problem
SOURCE: 2005 honda accord brake light does not work
have you checked the switch under the dash at the top of the brake pedal?? they come loose so may only need adjusting ........the pin on the switch has to be clear from the pedal to work if it still makes contact when you press pedal down then that will be the prob, if it still does not work when pin is clear of plate , take cable of switch and bridge them together if that works it the switch....... if still no lights fault is in the wiring loom/ relay or light unit
141 views
Usually answered in minutes!
×