door panel must come off.
go here for villager help
http://groups.yahoo.com/group/villagerquest/
Section 01-05: Trim, Interior
1997 Villager Workshop Manual
REMOVAL AND INSTALLATION
Trim Panel(s), Door
Front
Removal
-
Disconnect the battery ground cable (14301) if equipped with power locks or power windows.
-
CAUTION: Use care when removing the front door inside handle escutcheon (22620). Failure to do so can result in damage to the component.
Carefully pry off the front door inside handle escutcheon by inserting a standard 1/4 inch screwdriver between the top rear portion of the front door inside handle escutcheon and the front door trim panel (23942).
-
If equipped with manual windows, slip a clean shop rag between the window regulator handle (23342) and the front door trim panel.
-
Pull the shop rag back and forth to release the window regulator handle clip.
-
Remove the three cover caps and front door trim panel screws.
-
Remove the one front door trim panel capped screw from the door pull handle.
-
If equipped with power windows, remove the door pull handle. Disconnect the electrical connectors.
-
Slide a flat-bladed tool behind each of the retainers and twist the tool to disengage the front door trim panel from the front door (20124).
-
Remove the front door trim panel.
Installation
To install, reverse the removal procedure.
Body Side
Removal
-
Gently pry loose the body side door latch handle bezel and remove it.
-
Slide a suitable tool behind each of the retainers and twist the tool to disengage the body side door trim panel from the body side door (24622).
Installation
To install, reverse the removal procedure.
Door Electrical Connections
Removal and Installation
Refer to Section 01-11 for Power Window, Section 01-09 for Power Mirror, or Section 01-14B for Power Locks.
Watershield
Removal
-
Remove the Front Door Trim Panel . Refer to the removal procedure in this section.
-
Remove the front door watershield by carefully detaching it from the adhesive.
Installation
-
Install the front door watershield in the proper position and press firmly at the adhesive areas. If necessary, use additional adhesive to ensure an adequate seal.
-
Install the Front Door Trim Panel . Refer to the installation procedure in this section.
×