Need the precedure in changing headlight bulbs on a 2006 chrysler sebring
Behind the headlight you should see a eletrical wires running to the headlight section. There will be a 2 inch round plastic ring. You grap the back of the bulb and turn it to the right which will release the bulb and the socket. You pull out the bulb and replace it the same way. If this doesnt help then get back to me.
Hey sorry about that wrong car here is your info on how to change your headlights.
Raise the hood and look at the top of the metal cross member that holds
the radiator and fans and head light housings. Right next to the very
front fender on both sides of the vehicle and at the top of the head
light housings, you will see a small 7mm silver screw and right across
from it and on top of the head light housing, you will see a second 7mm
silver looking screw. These screws hold the head light housing to the
metal cross member. Remove the two screws and the head light assembly
is easily pulled forward enough to allow removal of the lamps. The
lamps have a locking tab on the plug assembly. Just press the plastic
tab and turn the lamp socket counter closckwise to remove it from the
lamp housing. Now, the lamp can be pulled from its socket holder. Don't
touch the new lamp with your fingers or it will cause the lamp to turn
dark and shorten its life. Assemble in the reverse order.
×
I drive a chrysler sebring. My lights were working fine until I stopped and started the car up. They would not trun on. I had to drive home in the dark. Help
5,731 views
Usually answered in minutes!
2006 chrysler sebring dash board speakers
cylinder layout 2006 chrysler sebring
how to replace headlight assembly on 08 Chrysler sebring
Where's the battery on a '98 chrysler sebring located and what's the easiest way to replace?
blinker bulb in front of 200 Chrysler
When i have the ignition turned to add, the headlights come on. I have turned the switch to off but the lights stay on.
×