Hi, 1. Start with the key out of the ignition, drivers door is open all others closed and 2. Perform these steps within 5 seconds. 3. Perform these steps within 40 seconds. 4. Perform these steps within 40 seconds. 5. Within 3 seconds, the power door locks should lock then unlock automatically 6. Perform these steps within 40 seconds. 7. Open drivers door.
The light for the keyless remote fob stays on? If so the battery may need replaced.
Here is link to a remote - LINK.IF this is yours get a battery @ your grocery store.
-open the key fob w/a flat screwdriver
-note the battery's position - is the '+' or the '-' visible?
-replace the batter the same way
-snap the cover back on
To reprogram (should also be in the Owner's manual):
drivers door is unlocked.
A. Insert the key into the ignition(Do NOT Turn) Pull key out.
B. Insert the key into the ignition(Do NOT Turn) Pull key out.
A. Close then open the drivers door.
B. Close then open the drivers door.
C. Insert the key into the ignition(Do NOT Turn) Pull key out.
A. Close then open the drivers door.
B. Close then open the drivers door.
C. Close the drivers door
D. Insert the key into ignition and leave it in ignition.
E. Turn the ignition to ON (Do NOT Start) then back to OFF.
F. Remove the key from the ignition.
indicating successful entry into programming mode.
Return to step 1 if the locks do not cycle at this point.
A. Press the lock and unlock buttons on the remtoe simutaneously for 1.5 seconds.
B. Immediately after letting go of the lock and unlock buttons,
Press the lock button by itself and hold for 2 seconds. Within 3 seconds, the door
locks should lock and then unlock once indicating successful programming. If
the door locks cycle twice, repeat steps A and B in step 6 as the remote was
not accepted.
C. Repeat steps A and B in step 6 for each new remote.
SOURCE: how to activate alarm 2001 bmw 325ix
locking and unlocking with the key is to deactivate the alarm not activate it, the alarm is activated every time the car is locked with the remote automatically, u need do nothing else
SOURCE: turn off alarm
put the key in the driver's side door key hole and turn the key to unlock it. Turn the key twice in the direction to unlock, I think it's top of the key towards the front of the car. Works on my wife's car
SOURCE: central locking not being activated by remote
somehow the car when on valet mode, go to a alarm shop , they should be able to re arm your car without to much damage to your pocket, or read your cars manual, it might inform you on how to fix the problem.
SOURCE: 97 toyota 4runner factory alarm not allowing to start
lock your doors and close it wait till alarm resets and then unlock door with key and this should take care of you problem
SOURCE: the factory alarm on my 2009 Toyota Rav4 was
Try to close doors and lock it with the key , not remote.
Then take the key out , wait 20-30 sec. and unlock it with the key.
After that try to start engine.
364 views
Usually answered in minutes!
×