P0341 ISUZU - Camshaft Position Sensor Performance
Possible causes- Faulty Camshaft Position Sensor
- Camshaft Position Sensor harness is open or shorted
- Camshaft Position Sensor circuit poor electrical connection
- Faulty starter motor
- Starting system circuit
- Dead (Weak) battery
SOURCE: 2002 isuzu rodeo won't start
Good day;
the clutch switch is located on the clutch pedal support, if you put your hand on the clutch pedal run your hand up and the switch will be at the top. now if you are going to replace this switch I would try to adjust the switch first the amount of time it takes and this would confirm that it's the switch. ensure clutch pedal is fully returned, disconnect the electrical connector from the switch. loosen lock nut and tighten clutch switch by hand until switch is firmly against clutch lever. back the switch out 1/2 turn, the switch plunger should extend .02-.06" (.5-1.5 mm).
hope this helps
Cheers
SOURCE: 2002 Isuzu Rodeo computer code p0446 probably from
diana2009: p0446 is a "Very" common code to pop up!
9 out of 10 times it has to do with the gas cap. The cap may have been loose or it may be failing. It is an EVAP code.
Do not buy an aftermarket cap! Buy an original equipment cap.
The aftermarket caps are often cheap, ones made in China and do not work or will not last very long.
Before spending money on any diagnostics in a shop, your truck is old enough where the cap could very well be the problem. It's a cheap enough gamble. You can probably get AutoZone to cancel the light for you for free.
SOURCE: 2000 isuzu rodeo trans range and leak problem at $1000?
I have a v6 2000 rodeo and the transmission contiunes to have a slip in it what should I do!! I have been having this problem since I purchased the car brand new in Oct 2000!! What should I do
SOURCE: where is the thermostat for a 2002 isuzu rodeo?
The thermostat is located at the end of the top radiator hose on engine.
SOURCE: FIring Order of a 2004 Isuzu Rodeo 3.2L Engine
My apologies for the delay....Due to the bad economy the number of questions posted has skyrocketed 50% in the last 4-months.
For 2WD and 4WD it is the same:
For 3.2L:
Firing Order:
1-2-3-4-5-6
Cylinders:
5-------6
3-------4
1-------2
(front of vehicle)
Coil is on the Spark Plug
Let me know if this helped, or if you have additional information or questions. Feel free to contact me at FixYa.com!
2.2L VIN D engine Firing order: 1-3-4-2 Distributorless ignition system
1,000 views
Usually answered in minutes!
×