20 Most Recent 2004 Isuzu Rodeo Questions & Answers


so this engine should be an 6VE1, this has got shims on top of the valves. So best to go to dealer for this unfortunately. I would only recommend you do it if you are a competent mechanic.
Valve Clearance Standard Value (cold)
Intake: 0.23 mm0.33 mm (0.0091 in0.0130 in)
Exhaust: 0.25 mm
0.35 mm (0.0098 in0.0138 in)
Selection of Adjusting Shim To select the correct size adjusting shim; Add the thickness of the shim removed to the measured valve clearance Subtract the appropriate valve clearance This will give the final figure, which is the thickness of the shim required.

2004 Isuzu Rodeo | Answered on Jun 04, 2019


Get yourself a can of starting fluid spray, and spray NO MORE than a two second burst into the air intake after removing the filter. Then crank it. If it fires (very briefly), your problem is low or no fuel delivery to the engine.

2004 Isuzu Rodeo | Answered on Nov 15, 2018


A mere 2,400km into the life of my 07 Rodeo TD 4WD, I used 4L for about 2km of medium-steep/slippery track. After stopping and selecting 2WD the 'Check 4WD' light appeared, meaning I was stuck in 2WD for the rest of that trip. Luckily I was able to complete the trip in 2WD without incident.

The dealer blamed me for 'not following the instructions in the manual' (utter codswallop), 'fixed' it, and very reluctantly gave me a scribbled set of instructions on resetting the system, which I've included below.

When I suggested that these instructions should be included in the manual, the response was 'not necessary if owners use the system correctly'. More cods.

Here's how to reset it:

1. Ignition off, hold all 3 buttons (2H, 4H & 4L) in together

2. Switch ignition on to 'reds' position (last position before start)

3. Hold in this state for 30 seconds

Hope this may be of use !!

2004 Isuzu Rodeo | Answered on Sep 06, 2018


Hi there is an adjusting nut behind the hand brake lever 10mm long socket will do it up, just spread the 2 rubbers look in and u fill find it 8 to 10 clicks tight is norm

2004 Isuzu Rodeo | Answered on Aug 13, 2018


try putting key in ignition turn to on position
then press lock & unlock several times slowly if door locks cycle up & down after 1st press it lost code and is now resynconised.
now try remote with all doors closed and key out of ignition
if this dont work need to register key(program)back into system which dealer must do with Tech2 if round heart shapped remote

2004 Isuzu Rodeo | Answered on Jul 07, 2018


The PCm has determined that during testing, ther fuel system for bank 2 was too rich. Can anyone know the solution?

2004 Isuzu Rodeo | Answered on May 04, 2018


I tried the DIY service and repair manuals from a website and it actually helped me repair transmission problem in my jcb 3cx site-master. it wont move forward or reverse, engine is good both solenoids for
forward and reverse work.
I don't have much technical knowledge but I just followed it step-wise, and works perfect! got it from www.reliable-store.com

2004 Isuzu Rodeo | Answered on Mar 23, 2018


There's this website www.reliable-store.com
They have books on ALL vehicles.
it covers wiring diagrams, electrical diagrams,
fuse diagram, torque specs, PCV, error codes, fault codes, service info, repair info, parts info, owner's/service/repair/parts/
maintenance manuals etc everything totally..
I have 1987 toyota 4runner model and I keep servicing and when needed repair it on my own. worth it !!!

2004 Isuzu Rodeo | Answered on Mar 18, 2018


You can try disconnecting the battery and see if that resets it. You will need to reprogram your radio possibly so have your anti theft radio code handy if your car is so equipped

2004 Isuzu Rodeo | Answered on Mar 17, 2018


check immobilizer , or main fuses

2004 Isuzu Rodeo | Answered on Jan 27, 2018


Sounds like you just do short journeys. Don't waste your money on a new CAT.
Warm the engine up and hold at 3500RPM for 10 minutes. That will heat up and dislodge any particles in the CAT and it should start working again.

2004 Isuzu Rodeo | Answered on Jan 12, 2018

Not finding what you are looking for?

767 questions posted

Ask a Question

Usually answered in minutes!

Popular Products

2001 Isuzu Rodeo
2001 Isuzu Rodeo

838 Questions

1999 Isuzu Rodeo
1999 Isuzu Rodeo

809 Questions

2000 Isuzu Rodeo
2000 Isuzu Rodeo

817 Questions

1998 Isuzu Rodeo
1998 Isuzu Rodeo

718 Questions

1995 Isuzu Rodeo
1995 Isuzu Rodeo

624 Questions

Top Isuzu Experts

Marvin
Marvin

Level 3 Expert

85020 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

459 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Rodeo Isuzu

  • Rodeo Isuzu

Most Popular Question

camshaft sensor located 2004 isuzu rodeo

  • Cars & Trucks
Loading...