Driver side wiper wont work

Question edited for clarity.
Question moved to model category.

Do they both sit perfectly about 4" up from the edge of the windshield rubber?

Winter snow and ice setting?

Usually fairly straightforward and intuitive once the interior trim panel has been removed from the tailgate. Often that is the most difficult part, though the nut retaining the wiper arm is often seized.

It can be faulty wiper motor or blown wiper control fuse.

Do you hear any kind of noise when you starter the wiper function.If yes then fuse is ok,but issue is wiper motor.
If no movement at all and no noise then its blown fuse or shorted/loose wiper control wiring:-----
For complete troubleshooting i suggest you few helpful links with accurate solutions.
-------------
Click the link below:-------

1993 Ford F350 wipers not working?

http://repairhelpcenter.blogspot.in/2012/02/1993-ford-f350-wipers-not-working.html
------------ How to Replace a Windshield Wiper Motor

http://schematicsdiagram.blogspot.com/2011/07/how-to-replace-windshield-wiper-motor.html

------------

Wipers not working, but hear relay click on Lincoln LS?

http://schematicsdiagram.blogspot.com/2011/12/wipers-not-workingbut-hear-relay-click.html

-----------

Car windshield wiper gets power for movement and stops?

http://schematicsdiagram.blogspot.com/2011/12/car-windshield-wiper-gets-power-for.html

----------

How does cars Windshield Wiper System Works

http://technoanswers.blogspot.com/2011/11/how-does-cars-windshield-wiper-system.html

---------

1997 Honda Protege: Replace Wiper Transmission?

http://technoanswers.blogspot.in/2012/06/1997-honda-protege-replace-wiper.html

----------------

Windshield wiper fluid container leaking?

http://whatisbyme.blogspot.in/2012/05/windshield-wiper-fluid-container.html

-----------------

Where is wiper fuse located on1993 chevrolet suburban

http://technoanswers.blogspot.in/2012/02/where-is-wiper-fuse-located-on1993.html

------------

2002 Toyota Sienna: Wipers and Passenger side Power window stopped working?

http://technoanswers.blogspot.in/2012/04/2002-toyota-sienna-wipers-and-passenger.html

-------------

Complete wiper components replacing details for Acura Car Models?

http://repairhelpcenter.blogspot.com/2011/11/complete-wiper-components-replacing.html

------------
These details will help.
Thanks.

Have you checked any fuses? Does the climate control light up? If the climate control also does not light up then I would check fuses. Check the under hood fuse box (left of drivers side) check the ECU-B fuse should be 7.5 amp. Check the heater fuse in the fuse box inside the car it should be 15 amp. If the fuses are OK and only the clock is bad check out my site www.autoclockrepair.com I offer a repair service for the highlander clock.

I have the 1990 model and just so happened to stumble on its unusual location today as I was replacing the door hinges. On the passenger side open the door and look above the step, there should be a little plastic cap with the wiper icon on it. hope this helps!

RE: 2002 Toyota Highlander 2.4cyl. 4X4 Base Model

I am a Certified Technician and have basic knowledge with electronics in electrical wiring. I searched the web and discovered this is a common problem.

I fixed the problem and it was a simple procedure... The problem is with the reverse light socket at the side with no brake light. This socket functions as a hub to direct current to the brake bulbs.

Remove reverse light socket and re-seat bulb. Check for loose or broken prongs. Replace if necessary.

Swap the reverse socket with the other side.

There should be a relay. Probably located in the PDU box under the hood. If not the motor might be going bad.

First check to see if the nut that holds your wiper to the shaft came loose. If it did, just tighten it. If it didn't , you'll have to look in through the access cover. Usually just a screen like cover at the bottom of your windshield. I'm not sure what the setup is on them, but most vehicles, this cover is just held on by screws. Remove your wiper/ wipers if necessary, remove the cover, and look inside. There should be a linkage bar that connects to your wiper motor. It may have come off, or be stripped. I'm sure you'll figure it out once you get that far. Good luck.

check wiring in the door. check power going to motor with a 12V test light of DOVM (digital volt ohm meter) while hitting the switch at the same time. then reverse the testing leads on volt meter. if theres a split or broken wire on in the drivers side front door then thats the problem and u will need to repair that

P1135 is the A/F sensor Bank 1 Sensor 1. Unfortunately, it is the sensor on the back side of the motor, in the manifold against the firewall. Its extremely common, and its not very difficult to replace, just dont try doing it with the motor hot. If you installed an aftermarket sensor, or an Oxygen sensor instead of A/F, you will still have problems. old exhaust gaskets tend to crumble, dont worry, your air mix didnt cause that. Which sensor was replaced?