Cars & Trucks Logo

Related Topics:

Anonymous Posted on Aug 12, 2012

1982 Ford F-250, Engine Runs with ignition Key turned from run to off..until lights are turned off, then engine stops

When engine is started, side marker lights are also dimly lit. All lights (Head/Tail/Turn) operate normally. But engine will continue running until lights are turned off with the switch. Is this a light switch or ignition switch problem?

  • Anonymous Aug 12, 2012

    Would that be at the ignition switch, or light switch? Thanks!

×

1 Answer

Anonymous

Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

  • Expert 186 Answers
  • Posted on Aug 12, 2012
Anonymous
Expert
Level 2:

An expert who has achieved level 2 by getting 100 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Sergeant:

An expert that has over 500 points.

Joined: Jul 29, 2012
Answers
186
Questions
1
Helped
75269
Points
522

Ignition is shorting with the light stalk check wireing

5 Related Answers

Dan Dubay

  • 65 Answers
  • Posted on Jun 21, 2008

SOURCE: ford mustang 1966 ignition problem.

The starter solinoid is bad.Clean and check battery cables also.

Ad
emissionwiz

Marvin

  • 85242 Answers
  • Posted on Jan 05, 2009

SOURCE: Engine will not shut off.

Have u checked the actuator linkage from the ignition lock cylinder down to the ignition switch on top of the steering column near the bottom under the dash? de-trim the steering column, there are four screws that hold the 2 halves of the cover on the column u access them from the lower cover, feel for the access holes with your finger, then u must drop the column down from the dash connection/support by removing the support screws to the column under the dash, they are 15mm, the cover screws i mentioned are Phillips head.

Anonymous

  • 1 Answer
  • Posted on Mar 26, 2009

SOURCE: 1999 ford windstar

i believe your vehicle is diesling; gas is still leaking in and motor keeps cranking.

Anonymous

  • 255 Answers
  • Posted on Apr 14, 2009

SOURCE: Ford 1995 F150 Truck. Turn ignition key off but Truck still runs

ignition switch electrical portoin above brake pedal on steering column

shack

wolfman21955

  • 97 Answers
  • Posted on Apr 23, 2009

SOURCE: Blows fuses when parking lights are turned on. Headlights work fine even running lights.

If it only happens when you turn the switchto the parking lights then it is most likely the swich that is the problem. Light swich failure appears to be a common fault with fords

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
1answer

2000 Ford Windstar engine still runs after ignition off and key out!!

Ford trucks have known issue with faulty instrument displays printed circuit boards.
0helpful
1answer

How do you time a 1966 ford f-250

There is one of two ways when the truck is started turn the distribator untill it runs good or get a timing gun
1helpful
2answers

I have f-250 diesel. keeps blowing fuse #22,glow plug controller. what might be the problem

You should start with the glow plug relay/timer.Check it to see if may be shorted.Remove the smaller wires going to it and turn the key back on,if the fuse does'nt blow then replace it,if it does then you need to unplug the fuel preheater in the filter housing and try the key on thing again,pretty sure it's one or the other.
0helpful
1answer

1979 ford f250 no lights buzzers radio engine start etc when i turn the key

Check for burnt fuse link(short piece of wire with tag) near starter solenoid.
0helpful
2answers

1982 Ford F250 5.8L starting problems

82 should be mechanical pump,drivers side in front of engine by oil filter,filter is inside fuel line at the carb
0helpful
2answers

MOTOR OPERTAES WITHOUT KEY

your starter,solenoid or ignition is no good. but my first choice,i think your solenoid is shorted because when you hook up the battery,it cranks but does not start.that means your ignition switch is still working.
0helpful
1answer

Engine won't crank or seem to get power on key turn.

More than likely, your starter has gone out. If the battery is fully charged and its not even turning over, that is what i would start with.
Not finding what you are looking for?

248 views

Ask a Question

Usually answered in minutes!

Top Ford Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...