Open sunroof that will not close.

Ok, so the first poster obviously didnt read the question and just posted the first thing he googled.

So I'll try.
You have a short, most likely on the actual drive motor itself or in the switch. I wouldn't bother with replacing the fuse again until you take the motor out or test the switch for a short.

You must remove the electric drive motor located at the front of the sunroof under a plastic cover, then close the glass and reinstall the motor drive.

try contacting a accessory shop that installs sunroofs,spoilers things like that i'm sure its only 100.00 and not 300.00

Do you know how to test automotive electrical circuit's with a DVOM - digital volt ohm meter ? When adjusting the moon roof did you see any switches ? sunroof limit switch
Measure the reference voltage of the sunroof limit switch soft stop signal circuit at the sunroof control harness connector to a good ground.
Does the reference voltage measure near the specified value?
4.5-5.5 V
Notice: Do not open the sunroof glass past the full open soft stop position. Doing so may damage the sunroof assembly and or the roof top.
Connect a jumper wire to the sunroof limit switch soft stop signal circuit at the sunroof control module harness to a good ground.
Turn ON the ignition, with the engine OFF.
Using the sunroof switch, operate the sunroof system, not to exceed the full open soft stop position.
Does the system operate as requested?

Do you know what a wiring diagram is ? Free one's here
http://www.bbbind.com/free_tsb.html Enter vehicle info. year ,make ,model an engine size . Under system click body & accessories ,then under subsystem click on sun roof . Click the search button then the blue link . See the control module , motor an the two switches ? One is probably miss adjusted . or bad !

Power Sunroof System Components
The power sunroof system consists of the following components:
• Sunroof control module
• Sunroof motor with the limit switches
• Sunroof switch
• Sunroof glass-spoiler type, with glass sliding above roof
• Sunshade
• Rail and track assembly upon which the sunroof glass rides
• Power sunroof system circuit breaker: PWR WDO 25 A
• Ground: G204

Sunroof Limit Switches
The sunroof limit switches track the position of the sunroof glass through two limit switches:
• Soft Stop limit switch through the sunroof limit switch soft stop signal circuit
• Vent Stop limit switch through the sunroof limit switch range signal circuit
The sunroof control module monitors the limit switches and based on the input combinations, determines the position of the sunroof glass. As a sunroof limit switch closes, the 5 volt reference will be shorted to the sunroof limit switch low reference circuit, pulling the 5 volt reference to 0 volts.
The sunroof control module monitors both sunroof switch input requests and based on the sunroof limit switch input combinations, will control an output to the sunroof motor, to drive the sunroof glass to the requested position.

Sunroof Motor
The sunroof has a bi-directional motor. When the motor is not operating both circuits are grounded. When the motor drives the sunroof glass in the direction from the closed to vent or vent to open position, the following occurs:
• Voltage is supplied to the sunroof motor open circuit.
• Ground is maintained to the sunroof motor close circuit.
When the motor drives the sunroof in the direction from the open to vent or vent to closed position, the following occurs:
• Voltage is supplied to the sunroof motor close circuit.
• Ground is maintained to the sunroof motor open circuit.
The sunroof control module is equipped with a timer circuit which stops the operation of the sunroof motor after 8 seconds.

The side steel mechanism maybe jammed or worn, or possible foreign object jammed within the mechanism. Ii will require taking the sunroof apart, unless you can free it. Possible sunroof mechanism replacement. Hopefully this helps

Some customers may comment that the sunroof will no longer respond to the control switch while in a vented, partially opened, or fully opened position.
Cause A software issue with the sunroof control module may cause the sunroof control module to incorrectly indicate a "closed" position, which may result in no power to the sunroof motor.
Correction Verify the customer concern. If a condition is present, replace the sunroof control module with a new sunroof control module, P/N 15847643. Refer to the Service Procedure in this bulletin.
Service Procedure

1. Verify the customer concern by opening and closing the sunroof. • If the sunroof will not open , check the power windows. - If the power windows are also inoperative, check the fuse. If the fuse has opened, refer to Corporate Bulletin Number 05-08-64-004 to install 30A circuit breaker. - If the power windows are fully functional, refer to "Power Sunroof Inoperative" diagnostics (SI Document ID# 1392967) in the Body section of the 2005 Chevrolet Equinox or Saturn VUE Service Manual. • If the sunroof will open (or is already open), but will not close , proceed to Step 2.
2. Replace the sunroof control module. Refer to "Sunroof Control Module Replacement" procedure in the Body section of the 2005 Chevrolet Equinox Service Manual (SI Document ID# 1196049) or Saturn VUE Service Manual (SI Document ID# 1710479).
3. Open and close the sunroof in order to confirm that the customer concern has been resolved.

Parts Information Part Number
Description
Qty
15847643
Sunroof Control Module
1

make it go back to the open position,look down the side of the tracks in the roof that the sun shade slides in and you will probable find the guides for the sunshade are jamming up the tracks. only way to replace them<4 one in each corner> is to remove the glass section and then close sunshade that will give access to the 4 guides which are available from dealer as a kit

check the seals the rubber around window has anyone put anything on top of your car open the sunroof check the inside as it closes / to move the sunroof up or down after resting there are bolts on ech side at front theat you can un bolt push up and tighten up/ thanks for using fix ya please rate my response thank you very much

try oiling the runners

You will have to remove the sunroof motor, and the sunroof glass. Then you can move the guide tracks seperately until they are in the closed position. Then you can put the glass and motor back in, remove the power source (fuse or disconnect wire harness) to prevent any accidental opening until you can get it fixed. Chances are that a guide track or cable is broken, this can be a costly fix. Do not take it to the dealership, they will only want to install a whole sunroof unit. Take it to a local shop that installs aftermarket sunroofs