Cars & Trucks Logo
Anonymous Posted on Apr 28, 2012

My remote key button got stuck and i cannot use it to open or lock the door system again. how and where do i get a replacement

Range rover sport 2006

1 Answer

Shade Tree All Repair

Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

  • Master 509 Answers
  • Posted on Apr 28, 2012
Shade Tree All Repair
Master
Level 3:

An expert who has achieved level 3 by getting 1000 points

All-Star:

An expert that got 10 achievements.

MVP:

An expert that got 5 achievements.

Vice President:

An expert whose answer got voted for 100 times.

Joined: Feb 12, 2010
Answers
509
Questions
0
Helped
187566
Points
1627

Well in some cases a local locksmith can repair your FOB remote to make it function again. But sadly the keys have to come England and Laser cut they will need your Vin# and proof of ownership as well. The transponder is in the key itself. But keep in mind once you get another key made it will render the absent keys useless and will not function in the Car again. So make sure you send your key now to be repaired along with the new key order purchase, or it will not work when the other key comes back.The dealer is really the only place to get these at the tune of around 300 Bucks each. Theft of these are tremendous and every effort is to protect the owner. Which is good and bad at the same time. Some places are cheaper but 1 mistake programming and it leaves your cars computer useless which will cost more to get it unlocked. SO there is no easy way to do this sorry The Dealer is it. Please rate my solution this is how i earn my achievements here on FixYa Thanks in advance.

5 Related Answers

Anonymous

  • 53 Answers
  • Posted on Jan 19, 2009

SOURCE: 1996 4.0 Range Rover won't unlock

This car is in super lock mode... when you press remote 2times to lock or when you lock with remote and try to unlock using key manually.

there is a 4 digit number to open the door, its like opening a safe, starting from the left(key in car door) it goes L/R/L/R. so if number code is 1234..... left 1, right 2, left 3, right 4.

or if this too troublesome you can ask landrover dealer to remove the KEYCODE.

happy trying.....
adrian/kk.

Ad

Salmaneid

  • 54 Answers
  • Posted on Jul 06, 2010

SOURCE: 2003 range rover power door locks do not work...

does the roof lamp work? if not then means your Vehicle in transport mode. to have it in normal mode you need to take it to a dealer or something equivalent to have the job done by approved diag. machine

Anonymous

  • 510 Answers
  • Posted on Mar 27, 2009

SOURCE: How do you reset the service mileage light on a

e mail [email protected] for download

Anonymous

  • 1 Answer
  • Posted on Dec 06, 2009

SOURCE: Range Rover Passenger Door Will Not Open

I have a 2002 land rover discovery and my passenger front door won't unlock with the interior lock button on the dash or with the key fob. The only way to unlock the door is to pull the handle on the inside of the door. Is the actuator bad?

Please help
Rover2163

Anonymous

  • 9 Answers
  • Posted on Feb 25, 2010

SOURCE: HOW DO YOU RESET SERVICE LIGHT ON A 2006 RANGE

reset service light. The SIA information is stored in the instrument cluster EEPROM and can only be reset by using T4. (Dealer tool)

Ad

Add Your Answer

×

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

0helpful
2answers
0helpful
1answer

How do you enable a range rover engine when key battery is flat

There is a sequence of left and right turns of the key in the driver's door that will reset your bECM (Rovers brain) if the following have been tried.
1. Replace batteries in remote and 're-sync by depressing lock button on remote while physically turning and locking the door. Don't release button until locked and key removed. Repeat for unlock button.
2. Disconnect negative/earth cable from battery. While disconnected open driver's door, turn ignition to position 2, return to battery leaving driver's door open and reconnect the negative cable. Proceed to ignition. Turn off completely. Close all doors and hood and attempt starting.
Should both of these methods fail, run a search here on fixya for "engine disabled Range Rover P38" This will take you to step by step instructions on resetting the bECM which I opened this post with. It has been covered many times here, including by myself, no reason to post it again.
Good Luck!
0helpful
1answer
7helpful
2answers

HOW I MAY CHANGE THE BATTERY FROM KEY REMOTE CONTROL

put the key into the ignition and turn to position 2 leave it for 10 mins it will charge the battery on the key remote
5helpful
1answer

I own a '99 Range Rover 4.6 hse. I recently reinstalled a battery that had gone dead. I cranked the engine but the alarm went off and the vehicle did not start. I am getting this message: gearbox fault. I...

Unfortunately, there is a trick to replacing the battery.
1) Open the Driver side door.
2) Open the Bonnet and take the battery cover off.
3) Use your remote to lock and unlock the car (keeping the driver side door open)
4) Pull the Negative Lead from the battery first, followed by the Positive Lead.
5) Change or replace with charged battery.
6) Closed down Bonnet.
7) Your windows, sunroof, and key FOB will not work... so follow the next steps.

7a) Insert your key, with door closed into the exterior lock on driver's side.
7b) While turning the key to lock the door, hold down the "lock" button on your remote for 5 seconds while in "lick" position
7c) Your remote will reset, and you should be able to use your remote now
7d) While driving, roll each window down twice. On your third attempt, you should only have to touch the window button, and the window will have reset

Enjoy your Rover!
MIke
5helpful
3answers

The remote key of my lr3 stops working what to do

Press the 2 buttons (open and close) on your remote at the same time holding down for 5 seconds.

This reprogrammes it automatically.
34helpful
3answers

Range Rover Passenger Door Will Not Open

I have a 2002 land rover discovery and my passenger front door won't unlock with the interior lock button on the dash or with the key fob. The only way to unlock the door is to pull the handle on the inside of the door. Is the actuator bad?

Please help
Rover2163
2helpful
4answers

1996 4.0 Range Rover won't unlock

This car is in super lock mode... when you press remote 2times to lock or when you lock with remote and try to unlock using key manually.

there is a 4 digit number to open the door, its like opening a safe, starting from the left(key in car door) it goes L/R/L/R. so if number code is 1234..... left 1, right 2, left 3, right 4.

or if this too troublesome you can ask landrover dealer to remove the KEYCODE.

happy trying.....
adrian/kk.
2helpful
2answers

Key alarm code

I'm haveing a problem with my 2006 RR Sport car alarm. I can lock the door with the remote, but my alarm keeps going off. It stops but continues to go off during the day. The only message that I have received in the recent month is that my "Bonnett was open". Found out my Bonnett is the hood. Made sure the hood was closed tight and I have not received the message. But the alarm keeps going off.
Not finding what you are looking for?

319 views

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

xxxxxx xxx

Level 3 Expert

5117 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...