Land Rover Cars & Trucks - Recent Questions, Troubleshooting & Support
HOW DO YOU RESET THE SERVICE INTERVAL INDICATOR ON
You can take it to a garage that can run diagnostics on your vehicle, as you need to plug in a laptop that has the diagnostic program on it and switch off the indicator. This also goes for engin mangement lights, airbag warning lights etc. As long as the garage has the correct diagnostic program they caan reset all the dash lights you want resetting. Hope this helps ;)
2006 Land Rover...
on Jun 07, 2019
Have a Kidtrax 12v land rover defender, fully charged the battery, checked output is 12v, but it barely moves
There are possibilities that come to mind.
The first (and I'm not familiar with your specific ride-on) is, often there is a speed limiter that only a parent can remove. It generally limits the speed to 1/2 full speed. Most often this is a screw located on the accelerator pedal that limits the pedal travel to 1/2 full range. Removing this screw will allow the toy to travel about 5 mph.
The second is the battery. Just because it develops 12 volts is no real indication that it can supply sufficient current to the motor. (Think CCA's as related to a car battery). Over-charging by leaving it connected more than 24 hours, or running it completely will damage these batteries and they wi never be able to produce sufficient output.
If there is no limiter artificially holding the speed down, I would try a new battery. Amazon has the best prices.
Land Rover Cars...
on Jun 05, 2019
REAR HATCH WON'T OPEN 08 HSE SPORT
Hello my range rover sport tailgate glass won't open so can anyone give me advice how to fix it and tell me what the problem is exactly if it is a fuse or something. Can you please text me on 07455527235 to tell me how to fix it or what the problem is. Thanks Shayaan
Land Rover Range...
on May 25, 2019
Windshield sprayer won't work on LR3
Check the fuse first - replace if blown
If that does not fix it, pull the tubes off the spray outlets in the hood to see if fluid come out of the hoses when the switch is used, If it does, the problem will be blocked jets - probably with wax.
If nothing comes out of the tubes, you have a failed washer pump OR a fault in the wiring. The latter can be checked with a probe or multimeter. There should be 12+ volts on the positive side. Also check the ground wire with the ohmeter - a common fault
Land Rover LR3...
on May 02, 2019
Not finding what you are looking for?