4x4 has three wires connected on neutral switch.
SOURCE: my reverse lights dont work checked fuses and bulbs all good
did you test for power to the bulbs, possibly a bad ground connection for the bulbs, or the selector lever is broken reverse sensor is usually on the trans
SOURCE: shifting lever doesnt lock
Likely the shift detent mechanism is broken. It's inside the unit and can be reached by removing the trans pan. It should be just inside where the shift lever goes through the case.
SOURCE: i have a 98 jeep cherokee 4L 4x4 automatic and the
It sounds like the shifter gear indicator is missaligned.When you put the transmission in reverse the shifter passes over a button/tab in the console that turns on the back up lights.If its missaligned they'll either come on before or after reverse or wont come on.Remove console,with ignition on,vehicle not running, put vehicle in reverse and align connector over button/tab so back up lights come on and tighten shifter indicator
SOURCE: 1995 jeep loredo woll not go in reverse or change
Shift linkage cable needs adjustment or replaced.
SOURCE: my reverse lights dont come
First, use a test light to determine if you have power at the light sockets. If you do, then check the socket grounds. If ground is good but there is no power, most likely problem is the reverse switch. Location varies with transmissions. On AW4 units it should be on the passenger side of the unit, Chrysler transmissions usually at the left rear corner above the pan rail. Stick shifts, usually on the left rear of the case.
506 views
Usually answered in minutes!
×