20 Most Recent 2006 Land Rover Range Rover Questions & Answers


turn on your bluetooth on your samsung while truck is on. it will scan for your range rover. phone will ask for code type in 2121. i have a samsung note 3 and thats the code i use. im assuming it"ll work on any samsung phone.

2006 Land Rover... | Answered 11 hours ago


Hi, thanks for your input. I can not see the images of the electric circuits well. Could you send me the personal attachments corresponding to the multifunction radio-display of a 2005 Range Rover L322? Could you tell me which cable sends the start key signal?
Many thanks
dr.frecalde@gmail.com

2006 Land Rover... | Answered on Mar 16, 2018


You car thinks it is or is in access mode or in extended height mode.

2006 Land Rover... | Answered on Sep 13, 2017


Try pushing the button again to reset the system. You can also look in the owner's manual for answers.

2006 Land Rover... | Answered on Nov 26, 2016


1 - Radiator
2 - Thermostat housing
3 - Radiator bottom hose
4 - Viscous fan
5 - Water pump
6 - Radiator top hose
7 - Heater return hose
8 - Coolant supply hose
9 - By-pass hose
10 - Radiator bleed (purge) hose
11 - Bleed (purge) hose, thermostat housing
12 - 'Y' piece ejector
13 - Expansion tank
14 - Heater rail
15 - Heater unit
16 - Heater feed hose
17 - Intercooler
18 - Air cleaner
19 - Air feed hose
20 - Turbocharger
21 - Charge air supply hose
22 - Cooled charge air supply hose
23 - Exhaust manifold
24 - Engine oil cooler
25 - Feed pipe, engine oil cooler
26 - Return pipe, engine oil cooler
27 - Oil filter
26264875-o0qmuaeri1ktexfeuzrayee3-3-0.png

2006 Land Rover... | Answered on Aug 22, 2016


replace Maxi fuse 64.

also follow this link it will help you out with a ton of stuff on your range rover.

http://www.rangerovers.net join the forum that they have. there are all kinds of range rover nuts out there.

I’m happy to help further over the phone at https://www.6ya.com/expert/dennis_7c5f8bf265aab5e9

2006 Land Rover... | Answered on Apr 26, 2016


Usually near the rear wheel same side tge gas cap is on

2006 Land Rover... | Answered on Apr 18, 2016


Possible causes of OBD code P0730
- Low transmission fluid level - Dirty transmission fluid - Shift solenoids - Shift solenoids harness or connectors - Transmission mechanical problems - Transmission hydraulic control circuit The Error code is generally activated on detection of the following conditions: The TCM has detected that the transmission is trying to mechanically shift to a lower gear than intended

Possible causes of OBD code P0735
- Low transmission fluid level - Dirty transmission fluid - Shift solenoids - Transmission mechanical problems - Transmission hydraulic control circuit The Error code is generally activated on detection of the following conditions: P0735 is detected when A/T cannot be shifted to the 5th gear position even if electrical circuit is good.

2006 Land Rover... | Answered on Jun 18, 2015


use some terminal grease the next time and clean the posts really well first . most home improvement store sell it in their electronics dept

2006 Land Rover... | Answered on Apr 05, 2015


check the inertia switch under the seat and reset up and back down.

2006 Land Rover... | Answered on Feb 15, 2015


encrypted software ----dealer only

2006 Land Rover... | Answered on Feb 13, 2015


See www.graemecooper.com.au for a full list of model codes

2006 Land Rover... | Answered on Jan 03, 2015


Hi,I thought they where in the boot as you look in the boot on the write behind the cover.

2006 Land Rover... | Answered on Dec 27, 2014


you can also disconnect the negative of your battery cable.

2006 Land Rover... | Answered on Nov 28, 2014


If you used this scanner to diagnose the problem in your car then you can use the scanner to reset he check engine light. An alternative is to remove you negative battery cable for 15-20 minutes, or if repair has been successful drive car for 50-150 miles ( not all in one day ), and let the cars computer relearn the correct functioning of new part. LUCK FRIEND.

2006 Land Rover... | Answered on Nov 28, 2014


the inside of the wiper could be stripped out and have no tension to move the wiper try pulling it off and changing it if not need to see how to take it of and maybe the motor could have stripped the gears inside itself.

2006 Land Rover... | Answered on Oct 09, 2014


Sounds like a fuel problem. With the switch in the "on" position, can you hear the pump running? Crack the union where the fuel line comes up to the injectors, crank the engine to see if fuel comes out. If not, check for power at the fuel pump (in the top of the fuel tank). You should have over 12V between the white wire and earth. Ignore the voltage of the green wire - that is the sender.

2006 Land Rover... | Answered on Sep 29, 2014


Land Rover OBD II Trouble Codes
but pressure control of what?

2006 Land Rover... | Answered on Jul 30, 2014


Likely, that is the sound of your "wear indicators" because your brake pads are worn.

2006 Land Rover... | Answered on Jul 19, 2014

Not finding what you are looking for?
2006 Land Rover Range Rover Logo

192 questions posted

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22484 Answers

Marvin
Marvin

Level 3 Expert

85206 Answers

Jonah Oneal

Level 3 Expert

14092 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

View Most Popular

Range Rover Land Rover

  • Range Rover Land Rover

Most Popular Question

no power blower motor fuse blower motor

  • Cars & Trucks
Loading...