20 Most Recent
1995 Dodge Intrepid Questions & Answers
Turn signals wont work
Reboot the computer. Yes, you have possibly scrambled it as cars have multiple computers.
What symptoms will a 1995 dodge i trepid give if the bcm is faulty?
If the car has a BCM rather than a number of discrete black boxes, the symptoms of a faulty one could be various as it controls or influences many on-car functions and equipment depending on what the manufacturer decided.
If you feel something is wrong there is little point in prejudging the situation because just like any computer controlled system there is a diagnostic process to be gone through using specialised equipment that usually discovers problems are caused by switches, sensors, interfaces or wiring troubles rather than the "brain".
It is only after the test procedure has been exhausted that a module should be considered faulty.
Windshield wipers
I've seen this problem before.
First check the fuse.
Second check to make sure the motor has a good ground. Easy way to do this is to take a wire and run it from the (-) negative side of the battery to a metal part of the wiper motor, be sure it is to bare metal as current will not flow through paint.
Third if the wipers still don't work, a voltage check is needed at the electrical connectors on the motor. This can be done with a voltage meter. Try every speed on the switch. If different readings are noticed at different speed settings then it's the motor.
Fourth if you notice no differences then it is probably the switch unless there are corroded or broken wires somewhere in the circuit.
Good luck and keep me posted
Why want my 1995 Dodge interpid start
unfortunately being a 95 that was the cross over year to obd2 todays scanners may plug or not and may read computer info or not another way to check codes on the older chryslers is to turn the ignition on and off three times third time leaving ignition forward watch the check engine light and it should start flashing count the flashes example three flashes and a pause then four more flashes would be code 34 each code should repeat it's self twice then moving to next code when codes are finished engine light will go out if any codes were missed you will have to repeat the three times on and off also recommend doing it a few times to make sure you have gotten the codes correct
Stalling at low idle
I don't know this specific car. But, if it has one, check your Idle Air Valve. This can cause the engine to stall. If you can hold the gas pedal and the engine will continue to run until you let off the gas, it is likely the IAV. It will not necessarily cause the engine to run rough. That could be a number of things like spark plugs, wires or dirty injectors. It could also be a compression problem. Is the check engine light on?
How do you install a trailer hitch?
Should come with complete instructions for your particular model car.
Have you purchased the hitch yet? Once you have the hitch and have reviewed the instructions, if you still have questions, please return and we will try to help you.
Please purchase your hitch from a brick and morter company in your neighborhood. An auto parts place iw where I would look. Don't try to save a couple bucks using mail order. It is hard to talk to the salesman of a mail order company with your concerns. You will also be assured of getting the proper hitch for your car the first time around.
Thank you for your questionat FixYa.com
Not finding what you are looking for?