20 Most Recent 2006 Dodge Sprinter Questions & Answers

215f is NOT hot, 250f is. take a tech with a scanner on a ride with you. and verify if the gauge is lying or not. I know of a Excellent Garage near Dryden if you are near there?

run the fault codes indicates an accelerator position sensor or throttle control motor problem

placed vehicle on top of mountain,, pushed it off cliff, cause no one could find a solution.....

Hello jwilliams.
Here is a picture of the front of the engine.
This should be what you are looking for.


Thank you for using FixYa.

KL

removing 2006 dodge sprinter brake switch

Have rear wheel wells checked for cracked seam sealer. The sealer is used at metal to metal joints to prevent the exhaust fumes from entering cab and when not applied right or missed this could happen..

The wiring loom that runs down the front near the radiator and intercooler is prone to rubbing and corroding and shorting out. Check this loom.

If it is in bad shape i'd recommend replacement as the turbo boost sensor wiring and some of the headlamp wiring is in this loom also, and these can cause costly problems and cause the turbo to fail if not replaced.

Without the manual for the position in the fuse box - all the fuses will have to be checked - one at a time .

Fuse for the washer pump is most likely under the hood of the car by the strut tower on the battery side

What lighting ? headlamps, turn signals , interior , dash etc... An what's wrong with the lights ?

Buy a haynes manual at advance

If you want everything about 2006 dodge sprinter or any other vihicle google CHILTON.COM there you can get whatever you want and need. Probably the best manuals in the world.

HERE'S A LINK ON REMOVING YOUR TRANSMISSION. Repair Guides Automatic Transmission Transmission Removal Installation...

NO!! Flush the brake lines again, and bleed properly.!!! 2 person job, Open bleeder valve pump peddle down, keep down and close fitting, Start with the furthist one first from master cylinder. REAR PAssenger,Rear drivers,Front pass and the Drivers side.!! Are you loosing fluid?? Brake light on?? Check all fitting could have a small leak. There is air in the system somewhere!! Check all vacuum hoses to the Master cylinder, the could crak and leak, GOOD LUCK !

Timing belt routing diagrams for cars and trucks? Click the link below:--- http://technoanswers.blogspot.com/2011/10/timing-belt-routing-diagrams-for-cars.html

Drive belt routing diagrams for cars and trucks? Click this link below:--- http://technoanswers.blogspot.com/2011/10/drive-belt-routing-diagrams-for-cars.html

drivers side under the seat open plastic door.