Top 10 2001 Oldsmobile Intrigue Questions & Answers

http://www.pdfoo.com/oldsmobile/307-11855-pdf.html

heres the link to the service manual
also you can order haynes manual for 2001 intrigue from haynes of chiltons repair manuals

http://99intrigue.shutterfly.com/headgasket/97

motor has probly failed-n hav it inspected n electrically tested-a repair manual is very helpful-may want to do code scan to confirm

It is a sign that you either have a bad wheel bearing or 1 off your speed censors on 1 of the tires is bad, I just had this problem with my olds alero, but it was a wheel bearing that needed replaced.

Hello suewagner.
The crank sensor is mounted above the starter motor on the firewall side of the engine. The sensor picks up the signal direct off of the crankshaft through a machined hole in the engine block.
I have removed them without dropping the starter but learned that in most cases it is easier to drop the starter down to access it.
Here is a diagram for you.



There you are, hope this helps you.
Take care,
KL

Plenty of videos on youtube !
How to test an electric air pump P0410 case study

You did not say what size engine, so here's for
3.1L, 3.4L, 3.5L, 3.8L
Hope this was helpful.

Removal & Installation To Remove:
ECT sensor 3.5L engine

1. Disconnect the battery ground cable.
2. Drain the coolant below the level of the engine coolant temperature (ECT) sensor.
3. Disconnect the ECT sensor electrical connector.
4. Carefully remove the ECT sensor.

To Install:
WARNING
Damage to the coolant sensor will affect the operation of the fuel control system.

1. Coat the ECT sensor threads with thread sealer.
2. Install the ECT sensor. Tighten the sensor to 15 ft lb (20 Nm) on 3.5L engines and 22 ft lb (30 Nm) on 3.8L engines.
3. Install the ECT sensor electrical connector.
4. Connect the battery ground cable.
5. Refill the cooling system using the recommended procedure.

how do i remove shifter knob on 2000 olds intrigue

Here is a pic....