20 Most Recent 2005 Ford Excursion - Page 5 Questions & Answers

Why are you changing the injectors, the failure rate is really tiny, if they are dirty have a Ford dealer do a factory cleaning, it really works wonders.

Best Manuals for the best solution of your problem visit this site

On the web: images for wiring diagram ford excursion

check that the pinion teeth is the same pitch as the starter motor that you took out . That is the only reason for the noise unless you have not refitted the motor correctly and it is out of alignment.

Begin with the basics.... INSPECT COOLANT LEVEL, Low ????,PRESSURE TEST SYSTEM, PRESSURE TEST RADIATOR/EXPANSION TANK CAP, INSPECT DRIVE BELT(s), INSPECT COOLANT HOSES, INSPECT HEATER HOSES, INSPECT BYPASS/MISC. COOLANT HOSES/PIPES, TEST THERMOSTAT OPERATION, INSPECT RADIATOR COOLING FAN(s)/CLUTCH OPERATION, INSPECT CONDENSER/AUXILARY COOLING FAN(s) OPERATION(s) INSPECT RADIATOR & CONDENSER FOR DEBRI, OBSERVE COOLANT TEMPERATURE GAUGE OPERATION, If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

Time for a pro !! If you need further help, reach me via phone at https://www.6ya.com/expert/ralph_2f0886b7d6af32ce

I know this is a silly question but did he clear the codes after replacing the glow plugs. The won't clear themselves

Can you perform a spark test? I would like to know if it has spark when it stalls. Also, if you have a can of starter fluid, wait for it to stall and not want to restart, the quickly spray some starter fluid into the intake. If it runs on the starter fluid, you have a fuel issue. You might also want to make sure the engine coolant level is fine and you aren't overheating. If you coolant level is low you may not know it is overheating since the coolant sensor isn't in coolant. It won't read air.

have you changed the soleniod

might need new oil pump