20 Most Recent 2008 Scion Xb Questions & Answers

I recently had my engine replaced in my 2002 grand marquis 4.6 with a 2009 crown Vic 5.4 engine and was running fine until I broke my ignition and tried to replace it myself I bought a new ignition switch didn't work so I bought a steering column and still won't start what do I d? I landed on this website reliable-store.com and they got me free manuals so I used it to repair and it works fine

You have an ABS problem. Visually check the speed sensors. You may be able to see one that is damaged. You may need to hook up a scanner to pinpoint the bad one.

could be a power steering fuse failure tat would be from motor or pump seizure take it to an accredited power steering shop for a proper diagnosis and test

Should be where an air goes to engine beside TPS sensor.

Check you drivers manual it will show where the fuse is located and give the correct fuse to replace. Posted on Dec 03, 2015

Check you drivers manual it will show where the fuse is located and give the correct fuse to replace.

then the switch is bad or you need to check even if the switch even has power or a good ground hope it helps...

Good morning Erik You should get what you need from reading through this thread : How to remove exterior door handle Scion XB Forum It sounds pretty straight forward. Good Luck! D

There is a video about this on line I would suggest that you get a paperback repair manual like a Haynes to help you if you do it yourself. Or sign up at Autozone.com and see if they have any downloadable free guides specific to XBs. Autozone won't spam you for signing up.

it is located in the engine compartment driver side you may need your owners manual to find out which one it is.

Where I hi-lited in top pic appears might be screw or pop in clip..it's too cold for me to go outside to look at mine, wanted to point it out. Anyway here is what is in the manual...Good luck.

There might be a specific reset procedure that must be followed for safety reasons when the airbag circuitry is disconnected. You will need the maintenance manual to determine the proper procedure. Also make sure all of the connections are correct. Btw, I’m available to help over the phone in case u need at https://www.6ya.com/expert/dave_fb2c45146b845cea

my xb scion 2005 back window wont work cod it be the fuse where is it.

You need an impact wrench and large socket to get the spindle nut off, also some use star pattern bolts to hold on the hub. Will require a torque wrench also for re install. Some models require separating the ball joints too, a spreader is helpful. Not a job for anyone without good tools and a good bit of mechanic experience.

none needed this person knows what they are talking about

well in my 07 tc I have to hold the trip indicator and then turn on the key, not sure if it will work for you, you can look under maintenance lights in owners manual, like I said it might be the same way

Hate to state the obvious, but have you checked fuses and fuseable links? Was neg. bat. term. disconnected when you were working on this? Reconnected?

first check to see if bulbs are good, next look for fuse to lights, check owners manual, it will tell you where fuse is, could be as simple as a bad fuse