20 Most Recent 2009 Honda Civic - Page 3 Questions & Answers

May be keyfob needs reprogramming to make it work line normal.

Keyfob remote reprogramming is not very difficult but on some cases it can be done by dealer service tools.

If the remote s faulty then key fob will not get programmed.

Insert the key in ignition. Turn the key to on position, and cycle the key three times off-on-off-on-off-on. Then with the key fob remote select your remote and then try to operate the vehicle with remote.

These are just the basic procedure, but sometimes it will not help.

On that case dealer is the only option.

---------

There is a related troubleshooting link mentioned below for remote key fob reprogramming. Click the link below to go through its details and procedure: -------

ANTITHEFT WILL NOT LET CAR TO START?

http://alltypesofpartsreplacing.blogspot.com/2012/12/keyfob-programming-reprogramming-car.html

---------

These will help.

Thanks.

connect battery and then use your key to lock and unl;ock the door try drivers door first. this will reset alarm.

does the green light on dash goe out when ignition turned on? Could be a problem with transponder key or remote battery

Go to YOU TUBE VIDEO & then enter your question There you can see it doneThere are a few thing you need to know if you have rusted screws

when you say wont start do you mean that doesnt kick or turns without any engine run.

behind front bumper.

Hi there:This is a Powertrain fault code, DTC P0843 - Transmission Fluid Pressure Sensor/Switch "A" Circuit HighGenerally this could be some gear pressure switch located behind the transmission was broke. Other details in THIS LINK.Hope this helps; also keep in mind that your feedback is important and I`ll appreciate your time and consideration if you leave some testimonial comment about this answer.Thank you for using FixYa, have a nice day.

I just had this happen today when I jump started my car due to leaving my head lights on. Call the honda dealership you got your car from, or if you bought it privately just call a honda dealership. They will tell you to press and hold the pre-set buttons 2 & 6 and it will give you a number, they will type it into their computer and they will be able to give you the code. You have to use the pre-set buttons on the radio to enter the code. That will fix the problem... If you already entered to many wrong codes it will not allow you to enter anymore... You will have to either wait an hour and then it will reset again and let you enter the code or you can disconnect the battery for 5-10 mins, reconnect it and then the radio will reset and ask you for the code again. Good luck guys!

Is it when your wheels are turned left on take off? sounds like drive shaft. check cv boot for split. if you know a mechanic they will know if it is the drive shaft as soon as they drive it. If it is a crook drive shaft theoreticly it can not come apart but very annoying & embarassing.

It sounds like u need cv axles and your rotors turned

Here is Honda Customer Relations email for Honda Automobiles http://automobiles.honda.com/information/customer-relations.aspx