Search engine are more efficient. If this isn't to your liking
https://taotao.zendesk.com/hc/en-us/articles/204167645-General-Torque-Spec-Settings-
try searching "clutch nut torque spec"
SOURCE: torque specks
hi 1999 chevy malibu head bolts 1-8 40 ft lbs bolts9-10 30 ft lbs tighten all bolts an additional 90 degrees
rod bearings 18 ft lbs plus additional 80 degrees
head
top row of bolts 9 3 1 5 7 bottom row 10 6 2 4 8 from left to right
SOURCE: pinion nut torque spec chev
Axle Preload and Backlash Specifications
8.0 Axle Preload and Backlash Specifications
Application
Specification
Metric
English
Backlash
0.08-0.25 mm
0.003-0.010 in
Backlash (Preferred)
0.13-0.18 mm
0.005-0.007 in
Pinion Bearing Preload, New Bearings
1.7-3.4 N·m
15-30 lb in
Pinion Bearing Preload, Used Bearings
1.1-2.3 N·m
10-20 lb in
Pinion and Differential Case Bearing Preload, New Bearings
3.4-6.2 N·m
30-55 lb in
Pinion and Differential Case Bearing Preload, Used Bearings
2.8-5.1 N·m
25-45 lb in
SOURCE: My 2000 Artic Cat ATV won't hold a charge. What is the problem?
my guess is either you need a new battery or you need to clean the spark plugs
SOURCE: I' m looking for the torque specs for a front hub
i have a 2002 HD and the deal told me 177 ft. lbs. good luck
SOURCE: I need the torque specs
The pinion nut does not have a torque spec. as in how tight the nut is. The amount of torque is measured in bearing preload. You will need a "torque to rotate" torque wrench. If you are using new bearings the torque spec. is 15-25 in. lbs. If you are using your old bearings the torque spec. is 10-20 in. lbs to rotate. To measure this you will need to tighten the nut in small increments then use the torque to rotate wrench to turn the pinion without the carrier/ ring gear installed. Repeat until desired torque is reached.
723 views
Usually answered in minutes!
×