Bought new pz20 carb for TaoTao 110. Throttle cable will not connect to the new carb is different than old. Existing throttle cable has a plastic cylinder with metal pick style throttle cable. @
SOURCE: Throttle Cable Stuck Wide Open?
you need to re coil the spring or replace it for it to pull back in to poistion
SOURCE: replaced throttle cable on pw50 but can't seem to get it adjusted
If I understand your problem correctly this may help. There should be a spring just a bit smaller diameter than the slide that mounts between the top of the slide and the bottom of the carb cap. No spring means no snap-back. I am assuming there are no kinks in the cable and the cable was routed correctly when installed. Lots of times if the cable is not routed properly the gas tank will "stretch" the cable when the tank is re-mounted. Route the cable properly and the problem goes away..... As far as the slack in the cable, there is a an adjusting screw on the top of the carb (where the cable ends) and an adjuster screw at the hand throttle also where the cable ends. Some bikes have an extra adjuster mid cable but I don't think yours does, (working from memory here). If none of the above work then my guess is that the parts counter handed you the wrong part.
SOURCE: Hi, I took out my carb on kawasaki el250 forgot
if you move the throttle linkage on the carb you will see which of the mounting holes rises and which goes the oppisite way. normally the front 1 is the pull and the rear is the push. do the same on the cables by twisting the throttle on and off so you can see which 1 goes which way. hope this helps
SOURCE: Poulan Lawntractor 13.5HP throttle linkage missing
The easiest thing for you to do is look at another mower that has a single cylinder Briggs at how the linkage is set up. They will all be the same linkage from 12 hp- 20 hp.
SOURCE: Emerson LD195EMX - just bought from Walmart,
Hey, most stations are not broadcasting analog anymore. That is why you are only getting 10 channels.
927 views
Usually answered in minutes!
×