TORK Hardware & Accessories - Popular Questions, Answers, Tips & Manuals
Can I reuse the rear spinal nut on my 2000 ford focus ?
It is generally not recommended to reuse a critical fastener like the rear spinal nut on your 2000 Ford Focus. These nuts are designed to provide a precise amount of clamping force and ensure proper alignment of the rear suspension, so reusing them may compromise the safety and performance of your vehicle.
My Tork timer goes on and off at the set pin times, but then it comes on in the evening when it's not supposed to?
If your Tork timer is turning on at times when it's not supposed to, there may be a few potential causes. Here are some things to check:
- Check the programming: Make sure the timer is programmed correctly and that you have set the correct on/off times.
- Check for stray signals: If your Tork timer is receiving stray signals from other devices, this could cause it to turn on or off unexpectedly. Try moving the timer to a different location, away from other electronics.
- Check the power source: Make sure the timer is receiving a steady power source. If the power is interrupted or fluctuates, it could cause the timer to malfunction.
- Check for interference: Interference from other electronics, such as nearby radios or TVs, could be causing the timer to malfunction. Try moving the timer to a different location or turning off nearby electronics to see if this solves the problem.
If none of these solutions work, it's possible that there is a problem with the timer itself and it may need to be repaired or replaced.
Need help installing the Tork RZ 307 Timer - I have a white wire a black wire and a copper ground wire - the RZ307 comes with multiple colored wires - how do I install it?
Do not attempt to install this unless you capable and comfortable doing it,have correct tools and meters. you could receive a lethal shock, may start a fire. Call electrician. it will cheaper and less dangerous I had a trip to er for cut thumb, bill was around $2000.00 but I have excellent insurance and paid my $50.00
you need to look a instructions very carefully. your homes black wire goes to black wire. The copper will attach to switch mounting plate.
. the load side side is where attach the light or whatever the blue wire will attach to black wire fro load the white wire will attach to wire on load side.
Connect black and blue wires as shown in the diagram.
Cap the red wire
2. Depending upon line voltage, connect the mounting strap
green wire to either
(a) the timer green wire (for 120VAC) or
(b) the timer green/yellow wire (for 277VAC)
and the ground. Cap all unused wires.
3.Mount the timer inside electrical box using 2 mounting
screws provided.
4.Install cover plate.
5.Turn power on at the electrical panel
Not finding what you are looking for?