Samsung Dishwashers - Page 9 - Recent Questions, Troubleshooting & Support

Hi, F2 means that the Main Control Board is not getting the right signal from the user interface, turn off the power to the machine & then go to you tube there are several videos showing the correct way to remove the screws to give you access to the inner door liner to check all the contacts are clean & connected properly, as if this doesn't correct it then the user interface is probably the cause as it is most likely faulty & needs to be replaced, but to be sure I would follow the step by step tutorial on you tube for your make & model....

I hope this helps....

For what model exactly??

you are looking for the main control board on your washer it is located under the unit if you are experienced with this type of basic electronics follow the video below to locate and remove but by all means shut the circuit breaker off first before attempting any repairs. Samsung Dishwasher Main Control Board DD8201139B

Have you checked the water filter?

here's a site with some answers... https://www.repairclinic.com/RepairHelp/How-To-Fix-A-Dishwasher/26---/Dishwasher-not-draining you can chat or live 800 if confused. hope the site helps you.

Replace the heating element. It isn't seeing temp rise in set time

Wash pump could be faulty, the arms could be blocked

There is a nice repair guide with videos that provides troubleshooting steps and instructions for your dishwasher here: Samsung Dishwasher Making Noise

That seems to me to be normal unless you have a "Quick wash" cycle that you can select.

Error Code: 0E Reason For Error Code: OVER-FLOW ERROR Overflow error Repair and or check: Unplug the dishwasher to disconnect electrical power. If water continues to fill the tub, replace the water inlet. If filling stops when you disconnect power than replace the main power board assembly. Parts Needed: Water inlet valve or Main power board assembly