Clarke Tools & Hardware - Others - Recent Questions, Troubleshooting & Support

Question edited for clarity.Question moved from Welding tools category.I have the same unit! Unfortunately not much available for it now. You could have one made at an engineering shop locally.https://www.google.com/search?q=Clarke+BT1009+parts..

Your drum might be messed up. Sand paper needs to be cut square so its tight all around.

https://www.manualslib.com/manual/28711/Clarke-Ez-8.html The website has a downloadable manual. There are contact numbers for technical support if you need them.

I strongly suspect the item is of generic Far Eastern manufacture (label engineered) and with minimal parts backup. If parts are available they will be sourced from Clarke Tools or Machine Mart.

the electric field or is bearing position 6008 in good condition ? ? ? clarke obs 18 parts diagram Google zoeken

Hi Kirk Have you tried the Manufacturers site.. Doubt if any of our guys go that deep

Hi there did it smoke or smell funny or did it just stop either way check the drive/run capacitor that is usually what will stop them from starting/running

Where the wires are they should be a Diagram of 110 to 220 make sure you got the right wires on the right spot.