Balboa Instruments Garden - Recent Questions, Troubleshooting & Support

You have it in "Sleep" mode. Spa will not heat normally in this mode... If the SL Message is Alternating with the Water Temp in the Display Screen (we call this "Flashing Sleep"), the Spa is Operating in the Sleep Heating Mode. If the SL Message is ON Solid (Not Flashing) in the Display window of the panel, the Spa is Operating in the Sleep Heating Mode, but there is No current water temperature because the Spa is between Filter Cycles. Between Filter Cycles, while in the Economy or Sleep Heating Modes, the Pump has not turned ON and the Last Water Temperature is not Current. To read the Current Water Temperature, either Change to Standard Heating Mode or turn On the Heating Related Pump, and wait at least 2 Minutes. SL or SLP is one of the Modes you can program your spa into: EC - Economy ST/Std - Standard SL/SLP - Sleep It is advised you keep your spa in Standard mode. Push the Jets button then immediately push the light button. Each press of the light button will scroll between these three modes. Good Luck

Have you cleaned or replaced the filter? Try removing the filter and running it, if the problem goes away , replace the filter. Cheers

Hold temperature UP & DOWN together for 6 seconds. or Balboa 7 button controls, both buttons to the left of the display screen & down temperature.

I have a Clearwater Spa with a LM8000 spa pack that the control module does not work. Can I purchase just the control module or do I have to replace the complete system? If I need to replace the complete system what system can I replace it with?

Check to see if something inside the control panel circuit board came apart or broke from being moved. These things were not designed to be moved around a bunch so you probably have a soder joint come loose or get disconnected.

there are at least two separate circuit breakers feeding your spa and two reset buttons. the circuit breakers are located a few feet away from the spa in an electrical box.

the reset buttons are in the mechanical space of the spa where the pump and heater are located.

Hello! I have a question about my Balboy 500Z. When the water is heated the motor pump is still running that means the pump runs all the time without interrupt even the water has it's temperature. Now my question: is it possible to turn of the pump? thank you for your quick answer! Greetings Beat from Switzerland

The hot tub is in 'Economy' mode.

If you have a 'mode' button, press it until 'STD' shows. This will put the system back into the Standard mode.

If you don't have a 'mode' button drop me an email with a picture of your keypad and I'll try to advise you on what to press. [email protected]

Regards,
Ian.
http://hottub.synthasite.com

Probably the only one who can provide you is the distribuitor of the board.