Questions & Answers for: Toyota Highlander wiper arm

wiper arm on. Remove the plastic trim on the wiper arm base, and tighten the 12 millimeter bolt. Please advise if this helps. Yes, removing the plastic trim and tightening the nut worked for me. On my

In the middle of the wiper arm facing outward is a clip, simply pull the clip up (no tools needed) and take the arm off.  Too simple, very different that all the other approaches for wiper blades

how to remove windshield wiper arms on a 2008 toyo... How to remove windshield wiper arms on a 2008 toyota highlander Front are standard clipon 26 inch and 20 inch. rear needs to be replaced by dealer

...wiper arm until it raises and locks into the service position. The wiper arm will stand by itself once you raise it past a certain point. Then find the clip on the underside of the wiper arm (rotate ...

wiper, can I tighten a bolt or something? yes you normally can un less is stripped from the arm to the links attach to the motor. can you see the beginning of the arm does have a nut? or you can see a

...wiper arm, I found that the nut that held the arm in place was only finger tight, which allowed the arm to raise slightly off the splined shaft. This caused the shaft to strip the splines out of the ...

...wiper arm has a cover on the left end that pops up after gently spreading the two bottom sides apart. That allows the arm to swing out for cleaning the window or replacing the blade. The wiper blade ...

...fairly straightforward and intuitive once the interior trim panel has been removed from the tailgate. Often that is the most difficult part, though the nut retaining the wiper arm is often

what to do if only one wiper works? open hood and check for an arm that connects both wipers. sounds like the wiper motor is ok, just disconnected from one wiper.

...Highlander wipers come on automatically no certain pattern just whenever won't shut off no matter the position on the wiper control arm Check the operation of the park switch inside the wiper