Questions & Answers for: BUFFALO type of grinder

need an on/off switch for a buffalo bench grinder model B-6CB 1/2 hp. 41/2 amp. serial #775713 I had the same problem with a Northern Tools bench grinder. These are made in China and parts are hard to

...is working fine. try it in different usb ports. Press windows key +R key so you can see run then type in run "devmgmt.msc" then press ok so you can see device manager uninstall all usb drivers

...grinder, the switch is gone. There are 2 black wires that go into the motor, does it make any difference which is the netural wire? 8809dan. The neutral line should never be switched--only the hot ...

need a switch for Buffalo grinder model B-6CB(P) serial #841224. Are they available? That entire older Buffalo line of grinders: N-10CB, B-8CB, B-6CB, bgbr-6cb all use the same push pull switch.Most ...

starting coil switch I had to replace a bearing on my buffalo bench grinder and I cant figure out to put the starting coil switch back on or how it works A coil is just that a coil and unless it has ...

...please help me out. i do not want to format my disk.thanks When you boot up to the log in screen type in administrator as user to log in if you cant log in during the boot up process you will see ...

Model #: B-8CB Serial #: 840417 need switch assy That entire older Buffalo line of grinders: N-10CB, B-8CB, B-6CB, bgbr-6cb all use the same push pull switch. Most of those grinders were dual-voltage ...

need a new switch for buffalo grinder model B-8CB That entire older Buffalo line of grinders: N-10CB, B-8CB, B-6CB, bgbr-6cb all use the same push pull switch. Most of those grinders were dual-voltage

I have a buffalo b-6cb grinder that won't start unless I manually give it a spin. I took the bottom off and found the switch but No capacitor. An adjustable centrifugal start relay and or capacitor ...