...husqvarna 350 that will start and idle perfectly but when I get on the throttle it dies out. I emptied the gas that was in the saw and replaced with fresh gas, still having the same problem. I'm ...
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...some fuel supply line and fired it up. it went straight to full power without me squeezing the trigger. this is too dangerous and i need info on how to resolve this problem. If you had this
Question about Craftsman 36cc, 16 In. Gas Chain Saw
Husqvarna 137poorly works at full throttle Hi there, I have a H-137, and for two years it worked perfectly. This year when I started it, at the idle it worked perfectly, but when I tried to saw and ...
...trigger. SOUNDS LIKE THROTTLE NEEDLE STUCK OPEN CHECK THROTTLE LINKAGE STICKING OR RETURN SPRING I'm not sure I understand the problem description but it sounds like normal behavior to me. The saws ...
Question about Forest & Garden No.967012396 345 16" Gas Chain Saw
...husqvarna 345 chainsaw carburetor Find the 2 screws. There will be a (h) high and (L) low. These are for hig rpms and low rpms. First tighten the screws. Then unscrew them about 1-1/4 turns. Then ...
trigger. Both H and L screws should be set 1-1/2 turns out from stop. Turn the idle speed screw two turns in from where it is now. When you had the carburetor apart, did the rubber diaphragm seem hard
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...chain is jammed with saw dust/debris (it doesn't take much) 3. the bar sprocket is damaged. 4. The chain guide teeth are damaged and not sliding through the bar guide groove smoothly 5. The chain is ...
...chain cannot rotate. (you provided no serial number, this may not be your saw Feb-2008) http://weborder.husqvarna.com/order_static/doc/HOUS/HOUS2008/HOUS2008_1151081-96.pdf If this is not the problem ...
Question about Forest & Garden #966906636 445 16" Gas Chain Saw
Husqvarna 2 cycle oil. All of a sudden started racing like the carb was stuck full open even when throttle trigger released. Then would just sputter and die. Engine speeding up on idle is normally due
Question about Forest & Garden #966906636 445 16" Gas Chain Saw
...were broken in the clutch. If the engine doesn't stall immediately when the trigger is released and you notice the chain running slowly and the saw cuts out on idle, it might be the
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions