...seal enough to prevent water seepage that causes the flush to cycle every half hour. This is an Eljer 1.6 gal one-piece toilet Replace flapper, it is worn out.Turn off water valve. Flush toilet, ...
...seal properly. I have tried at least three different flappers. The toilet is in good condition and ablut 20 years old. i had same problem. higher end toilets use specialised parts, and the regular ...
...threw my eljer toilet? seem to happen of and on it flushes fine no flow troubles but over nite the room starts to smell..can it be coming in the holes around the bowl? Check the seal under the
...toilet runs, then either the fill valve is defective or the seal on the flush valve is defective. First, check to see that when you move the float, the toilet stops running. If it does not, then ...
sewer oder from toilet replaced wax ring dident sewer oder from toilet replaced wax ring dident help The wax ring would only help if the toilet wasn't sealed to the drain. Is the odor coming up ...
Question about Toilet Onepiece Canterbury 081162047
...floater is at a right height. Replaced the rubber flopper. I can see that the water is running into toilet bowl from small holes on the inside ring of the toilet. How can I solve this problem? Hi, ...
Question about Walford Two-Piece Pressure-Assist Toilet - 091-7925/Ch
...toilet, Eljer, maybe 1964. The flapper no longer seals. What can I do? Can I find the flapper? Can I put a new tank on the old bowl? Remove the tank. Remove the flush valve and replace with a new ...
...razor blade and the problem was fixed. I like to use chlorine-based toilet freshener tablets in my toilet tanks and I think these may attack the rubber of the seal and make
Question about 141-0220-00 Toilet Tank White
...toilet bowl... they are pretty universal. Does the current tank have a crack or something?you can replace the seals easilly enough if the tank is just leaking at the seal ... and the flush mechanism ...
Question about Toilet Twopiece Murray 091017000
...seal properly so the toilet continues to run. I must go in and manually push down the ballcock to create the seal. Have replaced the ballcock and rod. Did not help. Your best course of action is to ...
Usually answered in minutes!
52 Questions
17 Questions
15 Questions
11 Questions