Questions & Answers for: Pride Mobility Products thumb lever

...going to the throttle pod, its just 2 thin wires and if they were switched already you will probably be able to switch them back. The throttle pod is what the thumb throttle lever is hooked up

...thumb touching the lever just a tid, the scooter will only move a little then stop, or not work at all. this is a safty. Usally I change out the throttle pot and the Key switch (speed pot) together. ...

...It makes no sound when engaging thumb switch. Make sure the drive lever/freewheel brake is engaged. Usually it is on the lower back bottom of the scooter or check your owner's manual. Good

My wife's Pride Legend scooter can not be placed into FreeWheel mode. There a several solutions to this problem and all involve removing the seat and rear cover of the drivetrain. The brake and lever ...

Beep code 5 keeps going off, the manual freewheel lever is in the drive position. Can I repair it? Hi remove the key for a short while make sure freewheel lever is in drive & replace key & try

Why won't my scooter freewheel? If the brake release lever is not working by this I mean the lever will not move the release position, this could be a case of the brake mechanism has seized up due to ...

My Pride GOGO scooter is stuck in drive and the lever won't change to free wheel? try some wd40 and free the lever.

pride wrangler pmv-600 goes in reverse on forward lever I installed a new motor. When I press forward lever it goes in reverse. Check the polarity of the motor harness at the controller.

my pride jazzy electric powerchair will not unlock on one wheel, it only has one lever in back to release both wheels Your jazzy chair should have 2 levers. There is a lever for each wheel. if the ...

beep code 5.. wont move hi Taffie, that related to the freewheel lever or brake make sure the at the lever is not bent and make sure connection to the brake are okay , there is a micro-switch located ...