...would be the cable disconnect it and see if the Idle now drop all the way down, If not see if the throttlebody linkage is need of lube. Next turn it off take off the air intake hose Block the ...
...throttle plate and idle air passages. There are the first steps before you start throwing allot of parts and money at it. Paul These motors have MAP senors instead of MAF's... maybe coolant temp ...
...throttle plate. some of these are cleanable. it is held in with 2 8mm bolts. remove from throttle body and then seperate the solenoid from plunger by removing 2 phillips screws then you will be able ...
tried to clean throttle body out with carb, cleaner. it may have a buldup of carbon or dirt around throttle plate, not letting the plate to close all the way. also check for a vacuum leak in hoses etc
...throttle plate to control idle airflow as part of the sludge tolerant design. Throttle bodies with sludge tolerant design are clearly identified with a Yellow/Black decal. This decal warns that the ...
...throttle plate is limited to idle speed and limited vehicle speed (about 30mph) only. This can be caused by 2 or more APPS sensor failures or a stuck throttle related DTC. The above was from the ...
...throttle plate a bit when you turn the screw in. Idle speed should be about 800 rpm's, with truck in drive, foot on brake, and engine at normal operating temperature. If it still dies with the idle ...
my car rev itself on idle Check for an upper intake vacuum leak. Also check the throttle plate for sticking
...throttle plate and surrounding bore with an old tooth brush and some carb cleaner. Be sure to spray some into the small holes next to the throttle plate. That should help stabilize the idle. If it ...
...throttle plate and surrounding bore with an old tooth brush and some carb cleaner. Be sure to spray some into the small holes next to the throttle plate. That should help stabilize the idle. If it ...
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions