Questions & Answers for: Chevrolet Colorado throttle plate

...this happens. No check engine light. I had the same exact problem on my 2004 Colorado (3.5L). Cleaned the MAF sensor (with MAF sensor cleaner) and throttle body/plate - cleared it right up. check ...

...throttle plate and do a top engine clean, the unburnt gas causes the throttle plate to stick so after driving the car and it warms up the plate opens up when you shut it down it cools off and the ...

...leaks, then would be a your air by-pass valve, could try what is called a throttle body cleaning, whick is cleaning the throttle body plate from sludge build up whick all fuel injection vehicles ...

THROTTLE PLATE THROTTLE SHAFT OR LINKAGE IS DAMAGED OR STICKING.PROBABLY HAVE REMOVE THROTTLE BODY ASSEMBLY REMOVE IDLE AIR CONTROL VALVE AND THROTTLE POSITION SENSOR.BUY CAN OF CARBURETOR OR THROTTLE

...throttle plate, and air flow ports, with a good spray choke cleaner. This is available at an auto parts store. Once reassembled, the low idle situation will be resolved. Good luck...Coop Try ...

...throttle plate to stick, or the throttle body itself is bad. you will need to have the system scanned for trouble codes first. the trouble code will give you a much better idea where the fault is. if ...

... this will cause not enough air around the throttle body. simply clean out the inside of the throttle body around the throttle plate and bore. you will need to use throttle body cleaner or carb ...

...just the rubber tip of the valve. You should also clean the orifice where the valve mounts into the throttle body to allow smooth operation. Might be best to remove air inlet hose from the air filter ...

...throttle plate. In order to decrease idle speed, the PCM commands the throttle closed reducing air flow into the engine and the idle speed decreases. In order to increase idle speed, the PCM commands ...

...rough for two minutes, than runs good Starts good, than after a minutes runs really rough, than after two minutes runs fine try cleaning the throttle plate with cleaner and air,also try new air ...