Questions & Answers for: Chevrolet Blazer starter bolts

Question about 1994 S-10 Blazer

2 Answers

starter after removing 2 bolts ? Seems to hangup on flywheel housing Have you removed the 2 nuts making electrical connection to the starter? I just did this and was able to get the starter out. Could

Ad

starter cane has broken,or the fly wheel bolts have loosened,or you have a broken flywheel.Removing starter is the only way to see witch problem you have.After removing starter,inspect the starter for

Ad

Question about 1997 Blazer

1 Answer

...starter. Loosen one of the bolts about halfway. (They're long bolts) Remove the other bolt. HOLD STARTER WITH ONE HAND and finish removing the other bolt. Trust me on the above statement. It hurts ...

Question about 1990 S-10 Blazer

1 Answer

...to remember/take a picture/ make a drawing/ or mark which wires go to what posts) Remove mounting bolts. Remove starter, replace with new starter Install mounting bolts Install electrical ...

...bolts or a starter in a 1997 Blazer. The old bolts bell housing bolts would not fit so I found new bolts. The starter from the 1997 bolts up to the new engine but would like to know if I should buy a ...

starter bolts. I have replaced them three times and they are all breaking after a day or two.I have had to drill them out twice now...i Check the starter and see if there is a provision for a front or

Question about 1991 S-10 Blazer

1 Answer

...the bell housing for the flywheel and slide it over enough to make room, third undo the starter mounting bolts and the starter should come out easier. And just reverse the steps for

Question about 1999 Blazer

3 Answers

...starter bolts are only threaded for a short portion and not all the way to the head intending to increase strength through the starter mount. I hope that I've helped. If so please rate my assistance ...

Question about 1998 Blazer

1 Answer

...starters bolts are on the outside of the starter case and you should be able to see the head of the bolts where they meet the case.Internal you would not see the bolt head against the outside

...nut with a cutoff wheel. If you have the 2 bolts off the starter should come off the car. Unless it has a hidden third bolt! Cut the damn wire if you have to. Don't forget to take off the little

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...