Questions & Answers for: Stoves spark module

...light is a spark jumping, I assume, If so, try lighting with a match or something (be careful of the sparker) if it lights you may need to adjust the angle of the module so it catches the gas

...(located on the burner gas valve) and a spark module. Because it is not simple to test these parts and find out which one is defective, we recommend to contact a professional appliance

...The igniters are all controlled by a main hub switch located under the cooktop panel. Replace the sparking igniters module to fix the sticky igniters problem. Regards.

...it can't be any different from other stoves.if none are sparking there should be a spark module in there or they could have separate modules,if you send the full model number i can look it up for ...

...clicking can only be stopped after replacing the igniter, if it tests fine then it means that the spark module is bad and needs replacement. Please get back to me if you have any other questions. ...

stoves 1100df hob burners will not auto ignite no sparks are produced hob burner stopped producing a spark so will not ignite. Gas is flowing as normal. More than likely the spark module has gone out.

Gas flows as normal. Hob burners will not ignite there is no spark to any of the burners but the gas is flowing as normal. More than likely the spark module has malfunctioned and needs to be replaced

...spark module unplugging all wires except for the two main, the module still ticks. tried unplugging each wire at the module and at spark witches sliding all 4 off to see if there was a short, still ...

...spark up with gas and go out will not run There is something wrong with your flame detection system... Try to clean the gap, sensor and the wires... If the wires all coated with grease, the grease ...