...expert advise. thanks I am afraid I bare bad news... the transmission is suffering from swollen selector fork bushings. ATF fluid swells the bushings up, it used to be what was used to lubricate ...
...to this light is this the shift position indicator like drive, park reverse, neutral? Transmission Selector Lever Removal Raise and support the vehicle. For additional information, refer to Section ...
... 7 1/2 amp check enigne light not related. ---------------------------------------------------- The selector lever lock can be moved mechanically out of position ?P" when for example the battery is ...
...a blower resistor or have a wiring problem. does it work for heat if so then you heater control selector is bad because ford uses grounds for switches. if not then its your fan motor that is bad. ...
and remove the fuel line bracket. On vehicles equipped with a automatic transaxle, remove the gear selector and the gear shift cable bracket from the transaxle. Remove the air cleaner support bracket
...but when i go to start it dosent do anything. when i hit the brake i here clicking behide the drive selector Try jump starting. Lights take alot less power than starter. I suspect you battery is in ...
Drove to a friends house and now the transmission selector wont take the vehicle out of park. Are the brake light coming on when you press the brake padle? If no then the brake light switch is out/not
The green o/d light stays on when I start the vehicle, the button on the gear selector does not work. IS it staying in o/d?
TRANS RANGE SENSOR PO 708 Code 708 is for a problem with the circuit for the gear shift range selector sensor. The sensor tells the computer what position the gear shift is in, such as drive or ...
...check your starter, most auto parts stores will check them for free. all so make sure your gear selector is in park. if you have a good battery and starter your car should turn
Usually answered in minutes!
1,305 Questions
630 Questions
345 Questions
361 Questions
333 Questions