Question about 1994 Park Avenue
...the use of special equipment, such as a scan tool.Read more: How to Read Codes Without a Scan Tool on a 1994 GM | eHow.com ...
Question about 2000 LeSabre
...scan tool. Does the scan tool power up? Go to Step 2 Go to Scan Tool Does Not Power Up in Data Link Communications 2 Turn ON the ignition, with the engine OFF. Attempt to establish communication with ...
...scan tool . Transmitter Programming Important: Up to 4 transmitters can be programmed. Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry ...
Question about 2007 LaCrosse CXL Sedan
...scan tool. Monitor the powertrain control module (PCM) for DTCs with a scan tool. If other DTCs are set, except DTC P0315, refer to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC ...
...scan tool that is airbag capable. If it is on due to a fault condition it will not stay off until the fault is corrected. Same scan tool can retrieve the codes. Some parts stores have scan tools that ...
...scan tool to cycle the system solenoid valves and run the pump in order to purge the air from the secondary circuits. These secondary circuits are normally closed off, and are only opened during ...
Question about 2004 Rendezvous
scan tool to program keyless entry remote . Install a scan tool. Use the scan tool in order to access programming: Vehicle Control System/Computer Integrating System/Module Setup/BCM/Program Key Fobs.
Question about 2005 LaCrosse
...scan tool. Monitor the powertrain control module (PCM) for DTCs with a scan tool. If other DTCs are set, except DTC P0315, refer to Diagnostic Trouble Code (DTC) List - Vehicle in Vehicle DTC ...
Question about 2005 LaCrosse
...scan tool to the vehicle. Turn ON the ignition, with the engine OFF. Insure that all power consuming devices are turned OFF on the vehicle. With a scan tool, select Request Info. under Service ...
Question about 2005 LaCrosse
scan tool. Use the scan tool in order to access programming: Vehicle Control System/Computer Integrating System/Module Setup/BCM/Program Key Fobs. Press the START soft key on the scan tool. Important:
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions