Questions & Answers for: rotor ohms

...up, then it stopped again without tripping the breaker. This sounds like a "flying open" in the rotor. Over time a small part of the wire that winds around the rotor has gotten cracked just

...rotor have what is called "carbon tracking" replace them they are quite inexpensive. also check the resistance of you coil the primary should be 1-3 ohms and the secondary should be 20000-30000 ohms ...

...good spark I have no spark at plugs coil has good spar. tried to ohm plugs nothing, same for wires. rotor cap and distributor cap seem ok wear is slight If you have spark at the coil then you have a ...

...ohms (rotor) 2.26-2.80 ohms (excitation) .26-.32/.28-.35 main or power windings. Note: unit running when appling 12 volts to brush pack. 2-5 second only, ( This test tells you the rotor & stotor ...

...things, you may need to unplug the unit, and remove the back panel (four phillip screws). Check the rotor, the big metal wheel on the back of the drum. There are two plugs toward the bottom of the ...

rotor 26.2 ohms stator red/blue .4ohms stator blue/gray .7 ohms stator gray/red .5 ohms As long as you have continuity through the stator and rotor windings, and no continuity from the windings to the

Honda EV 6010 generator, no pilot light. I am in need of the ohm resistance on the rotor and stator assy. Any help would be great. Check for burnt stator, if that ok dismantle the generator end, ...

...replace the regulator. I think Harley sells a kit that is priced fairly reasonable. But, check the rotor. I've seen one rotor that didn't have any magnetism in it. That's right, It was a ...

...for correct resistance and shorts. You will need a good ohm meter and teh exact readings mostly on a rotor approx 22ohm and stator can be less than 1 ohm, but zero ohms to ground on any lead or ...

...of the stator and rotor windings, and also each rotor/ring to ground (IE rotor shaft) All tests to ground should be 0 M ohms, stators vary but typically around 1ohm or so, and rotors approx ...