Questions & Answers for: Chrysler replaced water pump car wont start

replaced water pump, set timing and car still wont start but it backfires in the intank? sure the timing chain is set correctly

...replaced the Thermostat and also the cooling is fine, my motor does not het hot it stays at normal temperature it's just the heating system that some times heats and sometimes it doesn't. Low ...

...water...or the injectors could be clogged with dirt. Hearing the pump run doesn't mean that adequate pressure is reaching the engine...a fuel rail pressure tester will tell you if the pump and relay ...

...replaced the water pump timing chain and a cam gear every thing is right the timing marks the gear eberything but car wont start 2005 2.7 sebring remove and retime your distributor, sounds like it's ...

...water pump shaft. To find it out, start the car, and while in idle open the coolant bleeding valve. if you will see a coolant jet popping out then the water pump is O.K. Stop the engine and after ...

water pump, and crank shaft sensor plate replaced now the car wont start and when it does it wont accelerate more than 10mph...help please. i dont want to junk this car have you been able to check the

replaced water pump timing belt and idlers. well it had also blown the head gasket pulled head had reworked and installed then the fuel pump died. Replaced fuel pump assy. ran for two weeks fine, then

...water pump replaced cause of a anti freeze leak. they said I didn't need pump but my engine gaskets all had to b replaced so they did that plus sent heads to be plained. said they put new clamps on ...

replaced the belt and water pump. Lined everything up as per maint. manuel and turned it by hand 2x. Felt smooth and the marks seemed to Line up. Car wont start. Checked for spark. Good. Smell fuel so

...water pump and timing kit? i would say the metal is from the bearings. a timing chain would be a waste of effort at this point. if you get a used engine with 70000 miles or more, i would replace the ...