Questions & Answers for: Oldsmobile replace crankshaft position sensor 1999

crankshaft position sensor, ignition module, fuel filter, plugs and boots. Also has new battery and alternator. check your throttle position sensor When you replaced your CKP sensor, did you perform a

crankshaft pos. sensor is just above the oil filter. take out starter and oil filter and make sure buy a new oilfilter or just make sure that you dont destroy the one on the car . remove plug and then

...replace the crankshaft position sensor REMOVAL & INSTALLATION Disconnect the negative battery cable. Remove the serpentine drive belt from the crankshaft pulley. Raise and safely support the ...

...CRANKSHAFT POSITION (CKP) SENSOR Disconnect the negative battery cable. Turn the steering wheel to the full left position. Raise and safely support the vehicle. Detach the sensor harness connector ...

...the cam sensor is located According to Haynes Manual, the cam position sensor is located in the timing chain cover which is above the crankshaft on the left side of the timing cover. Good luck ...

...all around the crank pulley, and see no wires or anything that looks like the unit. THE 2.4L ENGINE CRANKSHAFT POSITION SENSOR LOCATED JUST ABOVE THE OIL FILTER.REMOVE OIL FILTER YOU WILL SEE

...crankshaft position sensor make the car **** hard like that, or is it possibly something else? I'm going to eventually get it put on a diagnostics machine soon, but I wanted to get a little ...

...p0385 Crankshaft Position (CKP) Sensor B Circuit p0386 Crankshaft Position Sensor B Circuit Range/Performance Make sure your crankshaft sensor is plugged in or replace the sensor if the plug is

how to replace crankshaft sensor in 1999 olds silhouette Where is the crCrankshaft position sensor located on a 1999 Oldsmobile silhouette 3400 V6

...crankshaft position sensor are defective. I would look at starter and solenoid to begin with make sure there is good wire connections at both or take stater to parts store have them put on machine to ...