Question about Factory-Reconditioned 2.5 HP Air Compressor MAC2400
...I have a Makita MAC 2400 twin stack air compressor. I don't seem to have a manual but the regulator does not regulate. The compressor does cut out at around 125 psi but I don't seem to be ...
Question about MAC5200 Electric Powered Air Compressors
...pressure to the regulated level you are looking for. If you haven't already, try turning up the regulator, if no more than 100psi build's, then it's a sure thing, bad pressure
Question about Mac2400 212 Hp 42gallon Twin Air Compressor
Makita MAC2400 2.5 hp compressor has started leaking from the regulator. Is there a repair for this? Thanks Replace the regulator, you can get a new one from the home depot or just about any good ...
The regulator is leaking air and will not support the air tool I am using They do not show the regulator as serviceable. It looks like you have to buy a complete new regulator. It is part #410028-E. ...
...showing equal pressure. One showes 120 psi on one and 130 on the other. It sounds to me like your regulator is shot. It is the knob you have been turning in the (-) direction. The gauge reading 120 ...
Question about MAC5200 Electric Powered Air Compressors
...yet I can't get any air from valves. Any suggestions would be appreciated. Plunger inside the regulator could be stuck or adjustment knob stripped. Let the air out of the tank and ...
Question about DC18RA Rapid Battery Charger For LiIon NiMh NiCd Batteries
110v been pluged into 240v so does not work.solutions Fault with the main power supply regulator board. Check and replace damaged component/s at its main power regulator [SMPS] section circuit. ...
Question about DC18RA Rapid Battery Charger For LiIon NiMh NiCd Batteries
my makita model 5200 air compressor regulator will not adjust pressure--replaced with a new one-- no change.help!! commpressor pumps up to pressure--shuts off--when pressure drops to 110 lbs restarts-
Question about & Sealed Mac2400 Big Bore 2.5 Hp Twin Stack Air Compressor Low Noise
where can I buy a Makita Mac2400 air compressor regulator Makita parts are available at WWW.toolpartsdirect.com A small universal regulator may also work if the fittings match-up. When using a ...
Question about & Sealed Mac2400 Big Bore 2.5 Hp Twin Stack Air Compressor Low Noise
Makita mac2400 compressor-The regulator knob now controls both gauges. The reg gauge is to the aluminum block, the tank gauge to one of the spare ports. I've tried swapping the tank line and the plug.
Usually answered in minutes!
19 Questions
9 Questions
6 Questions