Questions & Answers for: power pull

Question about Sharp Heating & Cooling

2 Answers

...Pull the power cord. 2. Hold the MODE button while plugging the unit back in, but do not let go of MODE 3. The unit will beep and start to operate 4. Let go of MODE and depress the Power button to ...

Ad

Question about X5470 All-In-One InkJet Printer

1 Answer

Power won't stay on...power cord must be pulled hard to one side When I release the power cord that I have been pulling hard to one side on the back of the Lexmark printer, it will shut off when no ...

Ad

Question about HERSEE PUSH-PULL SWITCH -- OFF-ON

1 Answer

...pull What wires goes to what lead? 3 terminals.. 1 power input & 2 x outputs Main positive goes to 1 terminal = power in to switch. The anchor goes to another terminal = power out from switch to ...

Question about K8MM-ILSR (MS6741030) Motherboard

2 Answers

...pull-up 8 PWR_SW_N Power Switch low reference pull-down to GND 9 RSVD_DNU Reserved. Do not use. -Jon You need to plug these into JFP2. The power led plugs into pins 2 and 4. The hard drive led plugs ...

Question about MS-6533EG-LM (MS-6533E-120) Motherboard

1 Answer

...pull-down to GND 6 PWR_SW_P Power Switch high reference pull-up 7 RST_SW_P Reset Switch high reference pull-up 8 PWR_SW_N Power Switch low reference pull-down to GND 9 RSVD_DNU Reserved. Do not

...and the power point is pulled through the front. The dash power point, the tabs can be released by reaching in the center opening, and pull it through the dash, then release the wiring

...PULL CORD WHICH SHOWS POWER LIGHT ON/OFF, NOW WHEN YOU PULL THE CORD THERE IS NO POWER AND NO WATER COMES OUT, I HAVE CHECKED THE FUSES PUT NONE HAVE TRIPPED AND THERE IS STILL POWER ELSEWHERE IN THE ...

Question about Satellite M35X-S149 Notebook

1 Answer

...power up 3. pull the hard drive and try to power up. If none of these helped then leave these components out and 5. remove one memory chip and try to boot 6. then pull the second one if applicable ...

Question about PIXMA MP600 all-In-One InkJet Printer

2 Answers

...pull on the wires. Check to make sure the power cord is good and snug, if no change the printer has a power supply problem, I usually find a blown fuse, shorted diodes, and sometimes a bad capacitor, ...

Question about Powermate Powermate 5000W Generator

1 Answer

...Power Generators pull cord won t retract questions and answers. Ask your pull cordwon t ... Question about Powermate Powermate 5000W Generator. 2 Answers ยท I was running my coleman powermate 6250 gen ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Heating & Cooling Experts

Paul Carew

Level 3 Expert

3808 Answers

john h

Level 3 Expert

29494 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Heating & Cooling Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...