Questions & Answers for: ninja stopped working Cars & Trucks

my ninja wont start i have i Kawasaki ninja ex 500 one day i got on the highway and the rear wheel locked up and i heard a bang i drive a little bit and got off the highway i down shifted and the ...

with a C clamp you can push the caliper back so that you have clearance when you put it back on... [ninja edit]Just be sure you lay one of the old pads across the piston, the put the C clamp in place.

...ninja 250 05 cleaned carbs still dont start what to do next Spray a little starting fluid in it there and try to get it to fire up and then get on the throttle to blow out anything from the carbs. ...

Where is fuse box on 2009 kz500r ninja It should be under the seat near the battery box.

85 600r Ninja runs idles up n down run 70 mph for 10 mins engine dies and then hard to start You are in the wrong prduct section, this is for cars and trucks.

the headlights on my 2001 kawasaki ninja zx12r have quit working.i replaced the bulbs and they're still not working.What could be the problem? Check fuse...

i noticed my needle in my tachometer on my 2012 ninja going up an down while im at idle. Now it wont work at all and just sits at 0. What could be the problem? If the bike is accelerating fine then ...

...Ninja 600r and I need the fuel lines and vacuum lines diagram to put it back together. Does anyone know where these routing diagrams can be obtained, purchased or downloaded. Or if someone could ...

Can't find horse power information for the 1987 Ninja Zx250R that I owned for 20 years. I would love to know the horse power and all of the specs. I can't find anything online for pre 1988 models??? ...

2006 kawasaki ninja 250 will turn over but want start got ready to go to work took off went 2 miles and it died tried to crank it getting no fire Ricky, Try this link to the Ninja 250 discussion forum